Hello
I am looking at a Rinker 246 CC 2009 with volvo penta D3 190hp engine (diesel) and duoprop sterndrive. Anyone have experience with this setup.
Good? Underpowered? Engine issues?
Measure 9V on the oil pressure gauge. When the gauge stops working the multimeter shows 16V. Very strange.
Maybe I just should disconnect 12V + and - and just hotwire from the neighbourinstrument?
I just bought the boat. I will empty one litre tomorrow to see if oil pressure gets better.
I really dont hope there is diesel in the oil, but I cant smell it or see it on the paper I wiped.
Oil is above maximum mark. It should be between. I had the dipstick outside engine a few hours before putting it im to avoid residue from dipstick tube.
Mercruiser 1.7 turbo diesel 2007. Two different gauges. I have changed oil pressure sender. The needle jumps a lot.
What could cause this? Sometimes it stays on 0 for a few minutes before it goes to normal. No smoke or other strange noises. Engine runs fine.
Hello. I have a mercruiser 1.7 engine with alpha one gen 2 drive.
Last year I changed gimbal etc.. If I go from forward to neutral, it goes well. If I go from reverse to neutral, it can be a little difficult to get it in neutral, I almost have to put the gear lever forward. What do you think...
Hi.
i replaced both trim tab upper hinge because one sensor didn't work.
After replacing them I need to calibrate them.on the eic5000 panel. Port and starboard red led flash alternately.
i press the sun and moon for 3 seconds. I press both tabs down. But the port and starboard upper yellow dont...
