FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
do you think change this screw out. I didn't notice it before. This one looks like it limits idle speed.
Or remove rubber plug this one would limit high speed
I have the all the choke parts would like to buy a hard wire linkage but haven't found one yet, but have the cable linkage. I believe purple and white goes to the choke.
I'll look again for the treaded tab under the stator plate. Is it on the block or stator plate
#1 and 14. Instructions say screw in to threaded flange under stator plate, along with a really bad picture. I have everything from that kit except the kill switch.
I am making a wiring harness from a big red plug extension cord. I haven't found where you would attach the purple wire on to the...
Hello I'm new to the forum, I have a 1992 Evinrude 9.9. I'm trying to get it set up as all remote, shift, throttle, start, steering. I have a couple of questions. In the remote control kit there is a screw for a throttle stop. Not sure where it and it's spring goes.
Anyone have suggestions for...
