Recent content by biteme12

  1. B

    flywheel revoval

    I have a 1989 v6 175 hp gmc inboard motor.I need to replace the flywheel.Do i need to pull the motor out,or can I replace the flywheel with the motor still in the boat.:confused:
  2. B

    6 hp lower unit removel

    I have a 1989 6 hp evenrude model e6rlcec that I need to change the lower unit gasket.I see 3 bolts to remove, is there any thing else I need to remove before I get started.
  3. B

    kicker motor ?

    I have a 18 foot chapprral 4.3 v6.Can I use a 15 inch short shaft out board for a kicker.Or do I need a long shaft for a kicker motor.
  4. B

    4.3 v6 intake manifold ?

    I have a 1987 4.3 v6 chev.the question is that the previous owner put two screws in the intake manifold on the left side of the motor by the choke side in-between 4 and 6 intake.looks like he try ed to block something.what are they for.i noticed a loud ticking noise on the lest side of the motor...
  5. B

    4.3 v6 timing/advance

    I have a thunderbolt iv ignition with a 4.3 v6.The motor starts fine idles fine.But when I rev the motor, the timing advances but sometimes the timing drops way low past 8 degrees and ides real low.I have verified this with a timing light.I have been trying to fix this for 2 weeks.Would the...
  6. B

    4.3 v6 dies after reving

    I have a 1986 Chaparral V6 4.3 MerCruiser, Thunderbolt IV 175 hp.. Serial B579723 Carborater is a two barrel McM 175 3304-9565 Working on the boat I replaced the head gaskets, intake gaskets, riser gaskets, and adjusted valve trains, by taking the slack out of the push rods, then turning the...
See more
Top