Recent content by bke

  1. B

    steering bracket

    I was wondering if I mount a talon on my 08 skeeter sl 190 if the 1 inch set back is going to mess with my steering bracket when I tilt the motor up. The 1 inch set back would come from using the new sandwich bracket.
  2. B

    Bolt grade

    I have to take my motor off to mount my talon on. I need to buy longer bolts. Was just wondering what grade of bolts should I buy?
  3. B

    recessed foot pedal tray

    I was wondering if anybody has seen a recessed foot pedal tray on a skeeter sl 190. I was just wondering if you can still fit your rods in rod storage area in the center. With a recessed foot pedal tray installed
  4. B

    minnkota talon

    I was wondering if anybody has seen a minnkota talon mounted on a skeeter sl 190?
  5. B

    06 yamaha f150 oil change

    I changed oil on my 06 yamaha. When I took the drain plug off there was no gasket on plug. The kit I bought came with one. Do I need to put that gasket on. The perdon that owned boat before me alwsys had a dealer change oil.
  6. B

    Part number for lower unit drain plug

    I was wondering if anybody new what the part number is for the lower unit drain plug washer for mercury 2001 125 elpto?
  7. B

    carb question

    I have a 2001 mercury 125 elpto when I have motor tilted up when I am fishing it seem like the gas in carbs drain pretty quick. I can fish for about an half an hour when I go to start the boat will start and then I give it gas it will die and then I have to pump the primer ball to get it...
  8. B

    shifts hard into neutral

    I have a 2001 125 elpto it is hard to shift into neutral from forward or reverse. I can't see any binding in the cable. I was wondering if there is to much preload on it. When it is in neutral the rpms are around 1300 rpms is that to high? When in forward gear the rpms go down to around 675 so I...
  9. B

    prop size

    What size prop do people usually run on 125 hp mercurys
  10. B

    angle of boat motor

    I was wondering are the rpms affected depending on how the motor is trimmed?
  11. B

    pro 50 LD

    i was wondering what year a yamaha Pro 50 LD is the serial number is 510269
  12. B

    pickup tube

    I was wondering if this what a pickup tube is suppose to look like.
  13. B

    warning module

    I have a 2001 mercury 125hp elpto I was looking on a diagram it doesn't show a warning module it only shows a rev limiter. Is there suppose to be a warning module on there. When I looked at the motor I could only find the rev limiter.
  14. B

    warning beep

    I have a 2001 Mercury 125hp elpto when I turn the key to run postion I don't get a beep. I was wondering if this model is suppose to have a beep. I can only find one tan wire back by the motor that isn't plugged into another wire. I read on other posts that some models don't have the beep when...
  15. B

    01 Mercury 125hp elpto starting procedure

    I was wondering if anyone had a starting procedure for 01 mercury 125hp elpto. It takes a few times to get the motor to turn over and keep running. After I get the motor started it runs fine. But if I fish for awhile the motor doesn"t like to start on the first crank either. Any thoughts.
See more
Top