1984 mercury 115 EL inline 6. I was out running WOT for about five minutes then Boat started coughing and dropped to 3500 RPM. I checked compression 125 to 130 in all six cylinders. Checked spark have spark on all six( used inline spark tester with light bulb). Changed fuel water separator, it...
I just picked up a mercury black max 200. I think it is early 80’s. Of course the tag is missing . I did grab a serial number from the freeze plug on the top left head it was 6305370. Can anyone give me more info on this motor? What year? What model number? Thanks in advance for any help.
Also...
I have a 1995 Carver 250 Express. Looks like a Searay. 28 O.A.L. Weighs 6100 pounds with fuel and water. I figure 7000-7500 pounds with all my stuff. It has a 260 H.P. Carbed 350 and a Sp-c1 outdrive it is a 1.95/1. It had a B-5 when I first bought it. Way over propped. I could only get...
I have a Bennett trim tab set up. I replaced the pump unit. I then noticed the blue wire has popped out of the connector on the boat side.if I shove it in everything works great. Can I buy just the brass female terminal ( one of four inside the connector)? Or do I have to buy the whole boat...
I am over propped. I have a set of Aluminum B-5 duo props and I would like to trade it for a set of B-4 duo props. If your not sure if they are what you need I would be willing to meet up somewhere in the middle and we can swap props, dunk our boats and sea trial them. At the end of the day we...
I picked up an older Dynous inflatable cheap. Seems to be in good shape, no seam de lamination or holes. It is not cracked or even faded even though it's bright orange so I am assuming it was taken care of pretty well. The guy I bought it from said it was made out of vulcanized rubber like a dry...
I have a 1994 Volvo Penta 5.7 Gipmda . I had a Jasper long block installed in december and made a deal with the mechanic to bring it in in April for final adjustments. He told me it was not idling correctly after the install so he winterized it and I took it home for the winter. I brought it to...
I have recently replaced my long block with a remanned by Jasper. I have had other posts asking about problems on the original block. The engine is a 1994 Volvo Penta Gipmda. I cant get it to run evenly enough to set the timing. I am getting code 42 (electronic spark timing) and code...
I just got word back from the mechanic. my engine which is a 1994 volvo penta GiPMDA has a knock. The #4 cylinder had a sunken intake valve and the #3 exhaust valve was burnt. He sent the heads out to be rebuilt put it back together and there is now a knock. he says i need a new engine. I was...
I have a volvo 5.7 gipmda. I have a couple of issues, the high pressure fuel pump is putting out 18 psi. It should be putting out a max of 13 psi. I ha e disconnected the feed to the tbi and blown through it and disconnect the return line to the fuel reservoir and blown through it so I know...
How do you set timing on a 5.7gipmda? I have a rinda codemate, I tried to set the timing using it but the closest I could get it and still have the engine running was 20 degrees advanced.
took the "S" terminal off my starter and tried to crank fuel pump did not run
I have a 5.7gipmda which has been hard to start since I bought it in March. It will crank until oil pressure builds then start. I got a suggestion from another forum to take off the "S" wire from the starter and see...
