I don't have the original oil tank cap for my 1986 Suzuki DT-75 and have modified a gas tank cap to fit which works well. But the gas tank cap is non-vented. Is the original Suzuki oil cap vented. and if not, how does the tank vent?
BTW, the gas tank cap threads were just a bit small, so a...
Hi folks, I have a 1986 Suzuki DT-75 that has two-piece, spring-loaded choke plates. I have also seen other DT-75 carbs with a solid one-piece choke plate. On my motor, the spring-loaded half of the choke plate is missing on the top and bottom cylinders. I can't imagine how that occurred but it...
I'm using this: https://www.harborfreight.com/in-line-spark-checker-63590.html
The intensity of the flash in the tester seems the same on both cylinders.
I have pulled the carb (getting good at that) and disassembled the fuel pump. I don't see any sign of a hole in the diaphragm, so it is not a visible tear, but I suppose a pinhole under pressure could make a difference. I will need to order a kit.
Meanwhile, any other thoughts from anyone on...
Well, the filter housing is on the side of the fuel pump. But I suppose I could just put a gasket there and mount the housing without the filter and put an inline filter in, but I'd rather put it back to the original configuration if I can. The first time I put it back together I had trouble...
Sounds like it's time to pull the carb (again--I'm getting good at it!) and put a kit in the fuel pump. While it's out I can look for that piece of the venturi and if I'm lucky see if I can fish it out of the reeds if it's there. I'll look at the reed arrangement in my spare block to see what...
Thanks to you both. I did not see droplets on the lower plug. I have not been into the fuel pump, how does a hole there foul the lower plug? Is it from gas feeding back into the crankcase via the pulse line? That would make sense given the symptoms I have noted.
As far as the possibility of...
Greetings all,
I have a 1976 Merc 200 serial number 4353XXX. I have owned and maintained this motor for more than 20 years, and have managed to keep it going with help from here and other Merc outboard related sites, so let me begin by saying thank you!
The current problem began earlier this...