Recent content by blusporttrac

  1. B

    Gap between prop and lower unit

    when i got ready to removed my prop to check the numbers on it, it seems to have approx 1/4" play when tightened all the way down is this ok?
  2. B

    What prop do i have

    What prop do i have. Checked last night and it was kind of hard to read but i think it says MICHIGAN 7 1 0 3 6.
  3. B

    Force 90 Question

    I have a 1996 - 1750 aluminum fish hawk side consul fishing boat. The boat is 17.5? long and very light and takes in no water. It has a 1997 90hp Force 2 stroke. Im not sure on the prop, i don?t see anything on it and will need to remove it to get the info, but wanted to know if the speed is...
  4. B

    sometimes bogs when placed in gear

    Ok I?m new to the boats and motors. I have a force 90hp 1996. My boat starts on fast ideal and choke when cold and runs great but sometimes ill start it place it in gear and it will bog a die. I then have to put it in natural rev it a bit then go back into gear to get it going. Is this normal. I...
  5. B

    rich\lean\adjustment question

    My 1997 outboard Force 90hp is cutting out sometimes at low ideal and\or when I put it in gear and begin to give it throttle. Does any one know the steps to adjust the idle and air\fuel mixture and where those screws are located.
  6. B

    engaging in gear help please

    I just purchased a 96 1750 Crestline fish hawk with a 97 90HP 2 stroke force. Took the boat out last night started right up. Placed it in gear slowly idled out past the no wake zone pushed the throttle forward a little and the motor revved up like it was in neutral. I placed it in neutral and...
See more
Top