I am a little confused about a buzzer sound that is coming from the throttle control/ ignition box. The sound is not very loud..it can be heard while the engine is at idle and close to the throttle controls. Moving the key around in the ignition changes the tone (sometimes) and/or it has gone...
I have a stainless steel prop on now that looks to have been ground down a few times, plus it is nicked up pretty bad. At close to WOT the boat went around 20MPH. I have been looking at other posts, but I am still confused on what type of prop to get. The boat is a 16' fiberglass trihull...
I have an 1982 Evinrude 90 HP v4 that has a chunk missing from the lower unit casing where the prop shaft comes out (about 1'' by 3/4). There is also a crack forming on the opposite side that is about 1' long. This hasn't effected the integrity of the seal/gear box yet. I am looking at lower...
I'm working on a 1982 Evinrude v4 90 HP outboard that has been sitting at least 2 years (maybe longer). Initial compression readings were 100 psi on two cylinders (same side) and 60 psi on the other two. Got the engine running - started very easy and ran fine. The next compression check was done...
