Recent content by boarnold

My fuel pump is now pumping if the engine quits. Even after oil pressure has dropped. I'm suspecting a faulty switch. One of the terminals wobbles. But I want to double check my wiring. I The terminals are not labeled on the switch. I do have a diagram of the switch terminals. But I don't know...

Thanks! I found the kit.

I ended up pumping out the oil. Lots of shiny sparkles. I'm going to run for a bit then change oil again.

https://photos.app.goo.gl/KZJ1whMaxUCdcAJT7 I have a teleflex steering cable. The part number appears to be ssc12473. I thought the last two digits were supposed to indicate the length in feet. There is also 13-5apr89 after the part number. I assume that is the length of the cable and then when...

Purrs like a kitten. Thanks for your help!

https://photos.app.goo.gl/jrBgTtxcUTKPQ1w58 I can't figure out which one is the common. #2 is NC and it says the other two are no. Can you tell which one is the common?

Thank you.

Ok. How does.the fuel pump operate on crank when there isn't a wire going to the yellow and red wire? Just for asking to try to understand.

Do I wire something to the starter terminal with the yellow and red wire? That's the cranking wire?

Should I still wire the NC terminal to the R terminal on the starter if there are no wires there?

I didn't have any purple wire or any wire on one of the starter terminals. Is that normal?

Also, I didn't have any wire on one of my terminals on the starter.

Am I right that when wired correctly the fuel pump will operate when cranking and when there is oil pressure at the sensor? Is the r terminal on the starter cranking?

https://photos.app.goo.gl/3kZoae9FYLiMxBfC8

I've been seeing that the 85 terminal is to be ground.