Re: Fine Tuning 1956 15hp evinrude Fastwin
Pictures aren't that great. I looked at it again and water is leaking out of weap holes that are located on the bottom of the cowling. It increases with the rpm's. I'm assuming that water is going up there to cool the engine and that wherever it...
I picked this engine up last year and just got around to working on it. Started right up in the test tank after I read starting instructions and turned the small knob wide open instead of at 3 like someone else instructed. Put her in gear and ran her for twenty minutes fine. Now I'm gonna try...
Ok. I picked one up last year hoping to use it, but the seller didn't tell me that the lower unit had water in it so I didn't have money to fix it. Now I do, but when I went to the marina they told me that it is probably was the drive shaft and that its impossible to fix. Does that sound...
Hey guys. loved the look of this engine. Bought off ebay for 290 and he ran it for me and it started on the fourth pull. Ran great. Put it in F & R no problems. He told me to top off the lower unit before taking my wife and kids on lake michigan but that the oil was clean. I guess water is...
Question. I am close to finishing and have decided I like the interior of the boat without the decorative side panels. My father is insisting the panels have some kind of structural significance since below them was a contured hard board on each side. Do I need them or not. I don't have a...
Ok new to the outboard thing. I have just purchased a 1972 Chrysler 35hp. I am confused by the controls. If I were to put the controls on the starboard side where I sit, either the control cables would be going toward the bow of the boat, or the handle would be facing down. What am I missing...
Restoring a 1971 Larson Lapline 14ft. Had a junk 55hp on it. Took it off and looking for a replacement. I have seen similar boats to this having engine sizes from 35hp to 60hp. Any thoughts on what size would be reasonable? I would like to take kids tubing, but no interest in getting up...
I am new to this. I have a big boat and figured on fixing up a small boat (1971 14ft Larson Lapline) this winter to occupy my time. I finished the interior felt pretty good and the last thing to do was get the motor running. The charity I bought it from said the water wasn't circulating and...
Have a 1971 14ft Larson Lapline rebuilding. I have cables down both sides doing a push pull on the motor. Not too smooth. Is there another system I can upgrade to?
Just picked this baby up for $495 on ebay. This will supplement my big boat when the waves on Lake Michigan are too high and we want a puddle jumper for the small inland lakes. Tubing and stuff.
Needs some work. Holes on bow look like they are from some windlass that he took off. I will...
