FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
disconnected main wiring harness and clean all the pins on one side (try to open the pins a little with small thin screwdriver for better contact) and all holes on the other side I then put dielect grease on them and I had spark again
just like I said in post#15
I had same problem tried everything then I unplugged the wiring harness and cleaned pins and pow! it works
lol. glad you found the problem
what about running a wire from battery pos term to coil directly?
if you look at wiring diagram the coil gets 12 volts from the purple wire coming from the alternator witch comes from the orange wire coming from the starter.. check if the orange wire and the red/purple wires coming from...
I have the alignment tool and I am going to buy the gimbal install tool that goes on it.
does anyone know how far down shaft the holes needs to be?
for gen 2 drive
my thermostat housing has 2 ports for sender.. the boat came with 2 of the same sendeers in it. the parts book shows 2 different senders/sensor?
are they supposed to be different? 1 temp sender for gauge and 1 sensor for alarm system?
