Recent content by BobList

  1. BobList

    6 hp carb problem

    I have a question.. my 1968ish 6hp only runs with the choke full on, and of course, has only half power... tells me, too much air, or not enough fuel... anyway, there a 3 ports on top of the carb... a cap and a shot plug on the channel the low idle screw goes into. To the left of this...
  2. BobList

    6hp Carb problem

    I have a question.. my 1968ish 6hp only runs with the choke full on, and of course, has only half power... tells me, too much air, or not enough fuel... anyway, there a 3 ports on top of the carb... a cap and a shot plug on the channel the low idle screw goes into. To the left of this...
  3. BobList

    6hp Carb problem

    I have a question.. my 1968ish 6hp only runs with the choke full on, and of course, has only half power... tells me, too much air, or not enough fuel... anyway, there a 3 ports on top of the carb... a cap and a shot plug on the channel the low idle screw goes into. To the left of this...
  4. BobList

    Trim/tilt electrical

    1988 125, anybody got a link to a wiring diagram for this system? Relays click , and after repeated attempts, circuit breaker pops. No warning, just worked on day, and not the next. Don't wanna guess current flow, I'd at least like to familiarize myself with the wiring circuit. Bob
  5. BobList

    quick and dirty yes/no answers!

    Can a bad voltage regulator/rectifier cause an engine to not run it's best? Force 125.
  6. BobList

    slick trick for installing gear shift arm

    Ok, this dummy took out the wrong screw to drain his gear oil. shifter arm and bushing completely out of whack, I screwed up good. talked to Frank A this morning, we both agreed ya gotta take the lower unit off, and quite possibly disassemble the prop shaft. I pulled the unit, saw the...
  7. BobList

    Lost a piece while trailering, need to know WHAT TO CALL IT to order one.

    Re: Lost a piece while trailering, need to know WHAT TO CALL IT to order one. Hundred bucks. I'll make one first! Bob
  8. BobList

    Lost a piece while trailering, need to know WHAT TO CALL IT to order one.

    I lost the steel rod that you put through the bracket on the outboard, that keeps it in the up position while trailering. You raise the motor, slide this bar in the trim adj holes, and put a large cotter pin to keep it from sliding out. It supports the engine. 88 Force 125. I need to know...
  9. BobList

    T-stat question

    88 Force 125.. the coolant flow thru this engine is designed in such a way that even if the t-stat is stuck shut, you can look at the pee-holes shooting a good flow and be lulled into thinking everything is ok? My engine was running great yesterday, and I was giving it the how fast can it...
  10. BobList

    Trailer parts

    Hello, all. I have a 2000 Karavan single axle with bunks. I need to repl a few brackets, they are the ones that support the bunks, that directly fasten to the wood., I believe they are called the swivel brackets tht bolt to the top of the supports, that are in turn U-bolted to the trailer...
  11. BobList

    tilt/trim relays

    Had the "up" relay stick on me today, (this happened once on the water, and a quick tap released it.. worked fine after that, put it on my "to do" list of things to take care of.).. Anyway, it now just clicks.. "down" relay works fine. So I decided to take it apart, clean the contacts...
  12. BobList

    Testing stator/bypass ing burned spot

    I have a known bad section on my stator,visibly oheated and burned. It supplies AC voltage for cd box for the 3/4 cyl. Spec is 600ish to 850ish ohms, I have 1.2 megomhs ( Correction, k ohms, 1,200 ohms ) It seems to run fine..but at times, power (speed) goes away, will come back after sitting...
  13. BobList

    Question for electrical guys smarter than me....

    I wanna check my rpm's on my outboard.. I got a busted tach. Too much money to replace it right now. I DO have a Fluke 78 Multi meter with tach capabilities. I DON'T have the inductive pickup option for said meter. I can get one for $80. Too much. I can also get a tiny-tach for $ 40. Too...
  14. BobList

    general performance?

    I'm new to boating that uses engines more powerful than a minn-kota 35#.. I now run a 125 outboard on a 16' fish n ski. In the morning.. no wind, calm water.. seems to fly.. later that afternoon, a little wind, and a rougher water, it feels like perfomance has degraded somewhat. Now I'm...
  15. BobList

    Force forum is now at 666 pages

    Coincidence?... or Force outboards are the Devil???.. YOU decide........ :^)
Top