I have a 1992 130 yamaha. It runs great. I noticed when I put the boat on the trailer and walked around the back I touched by the exhaust at midsection. I got shocked. I started touching all the outside of the motor and was getting shocked. Any suggestions. Thanks
My 95 6 cyl 150 intruder will run for an hour and then when I check the #4 plug it does not fire. I bought a new dual coil thinking that was the problem and the same results. After a while the same plug that was firing is not firing. Great compression and getting fuel.
I have two questions. Can I take my 92 130 pistons and put them in a newer block from the mid to late ninties and put that powerhead on my 1992 130 from exhaust down? Does anyone have a clean block for sale?
My 92 130 Yamaha ran great today until heading back to the boat ramp it did not sound right . I did not have full power to load the boat on the trailer. I checked spark, compression 130 on all 4 cyl. When I looked at the #2 plug then I had seen that it was milky. I went home and had extra head...
I had the gears go bad in my lower unit on my 130 last month.The dealer said he shimmed the new ones. Last week after running it for two hours I checked The magnet screw and found some shavings. No metal chunks like before itwas bad. I took the boat out today and ran for three hours. I checked...
I am rebuilding this engine and noticed where the sleeve meets below the main lower bearing there is a clip that is removable. Right next to that is a round almost like washer that is part of the crankshaft. This will spin when the engine is running. It sits on top of the seal. I think it will...
