I've tried everything suggested to others on this issue. I have even called my ISP and had things tested/checked. When I am logged in and go from the forum to a sub topic there's a freeze problem when scrolling down the page. I can't reply to a topic either...freezes. The weird part is when I'm...
Anybody know what a good all around prop pitch/diameter would be for this engine? I realize it's sort of a loaded question. The engine is on a 1997 Starcraft Fishmaster 1660 deep v hull ..factory dry weight said to be 654 lbs. but with me and gear and batteries probably more in the vicinity of...
J50TLEOD TWO cylinder slows down with the last tiny bit of throttle applied. Back off throttle a dab and it picks up speed slightly. Link and sync maybe? According to tach it only turns 33-3400 rpms, I realize tach could be off. Also engine runs cool..whatever lake water temp is what she pees...
I looked on the online store here for a thermostat kit for a 1995 50 hp Johnson J50TLEOD and there is no listing for that outboard. Maybe a dealer only item? :confused:
a bit from thru prop exhaust. 1995 J50TLEOD 50 hp. Scared me when I noticed it. Oil is jet black and sorta thick. I immediately pulled LU fill and drain plugs and checked it. It was fine.. I had just put fresh lube in at the onset of freezing weather. The only thing I can *guess* is I've been...
Johnson 50hp TLEOD two cylinder 1995. RPM's vary from 3100-3400 dependent on water, wind, load, ect. Just recently bought this boat/motor so I have no prior knowledge on whether it's always been this way or not. Previous owner sold his home and moved out west so he's unavailable for...
Trying to get a feel on plugs being wet on my 95 model 50hp Johnson J50TLEOD two cylinder. I've adjust, re-adjusted and then adjusted more and each time I pull plugs and inspect they are always wet. I can't help but think a healthy engine properly adjusted will burn clean, or am I wrong? How...
95 model 50hp J50TLEOD Johnson. Fuel tank is OMC Dura-Tank non-venting cap..it appears to be the cap that came with the tank according to BRP parts diagram. This tank is under deck (but portable). Problem is that a lot of pressure is building up causing leakage around the fuel hose connection...
I seen in a post you said the valve on the primer solenoid can be used for decarbing. Can you go into detail on this? Would it be better than removing the airbox and doing it thru the carbs? Getting ready to decarb before long and just wanted to know the best and most efficient way. I *assume*...
I've checked the iboat store, my local Johnson dealer and poked around the internet looking for a OMC tank fitting. It's a standard ( I guess ) fitting that the fuel hose clips on to. It's a fitting that the hose locks onto..identical to the end that connects to the outboard. The same fitting is...
On a 95 Johnson 50hp should the fuel cap have a vent or no? Picked up a little rig 3-4 weeks ago and trying to sort out some issues with it. To start with it had sat too long and carbs had to be rebuilt. (The plugs are now wet after fishing trips and get home and check them.) Today I went out...
has an issue not taking throttle. Cranks fine. Put it into gear and idle around fine. Give it throttle to plane and it just doesn't want to go. This is an ongoing issue. Just purchased the boat today and going to try to sort it out. Previous owner had pistons replaced (.020 overbore) in 06 with...
