FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
The tilt/trim assembly on my 75 hp Honda outboard started leaking a little oil a year or so ago. I've been adding oil compensate. I've always been able to tilt motor up and down until now. The motor's down and the only way I'm going to get it to tilt up is probably by using a jack or a...
I need to replace hub in a Michigan prop: stamped 13 X 15. Prop was seized to my '96 , 75 hp Honda. Had to use torch and special incantations to remove prop. Old rubber hub destroyed. Are the hubs for these (stainless) props all standard, such that I can give info regarding dia. and pitch...
My Shorelander, dual axle trailer is almost twenty years old. Other than brakes, lights and coupler everything on the trailer is original. Trailer has been used primarily in salt water and rust is one of my primary colors on this trailer. I have the trailer stored on blocks for the winter...
I have a 1996 vintage 75 hp Honda outboard. Is there a way to get the carburetors off of the engine without removing the intake manifold? I can't get to one cap screw that holds the flame arrestor/air box (black plastic can) on front of carbs. so, in the past I have removed manifolds (which...
