Yep!
Definitely a rookie mistake. Have o idea where the ball went, propably under the porch......
I have never taken apart a lower case so forgive my ignorance.
Bought the ball and installed everything, works perfect and no water intrusion.
Now, I read the service manual (got one from my...
Next problem.
I changed all seals in the lower unit, assembled everything and went to start it in the barrel.
Strangley it started in gear.
Sure, a lot of parts kind of fell out when I half-stripped the lower unit but there aren't that many loose parts.
The shift rod can't be adjusted as far...
Hi.
I have no need to upgrade to 30 at the moment. That's maybe something I might consider later if needed.
But the small butterfly opening at WOT is normal for the 25?
When I converted my old 9.9 to 15 the difference wasn't that big.
Hi.
I was "recently" active in this topic regarding my 9.9/15 and 18 problems and for this year I decided to go bigger.
https://forums.iboats.com/threads/tohatsu-9-9-d2-ignition-timing.735075/
I bought a 2006 M25C3 which I need some guidance on. The best would be to find a workshop/service...
Hey guys!
So I finally got the 18 and tested it yesterday.
I gained 1.5 knots (from 20 to 21.5), a bit disappointing.
Same boat, tubes inflated and checked and same weight.
The 9.9hp (15) had a 8.5 prop and the 18 has a 9.
Revs at WOT was 5700 on the 18.
Any ideas?
Check compression...
I'm back!
I got the engine tune-up can but haven't been able to use it yet (we have four seasons here and right now it snowing outside......).
BUT, I got an amazing deal on a m18e2 from -06 (the 9.9s are more valuable then the 18s here so I will probably get some money back).
Same weight as...
Hi everyone.
I would like to get a clarification regarding the ignition timing (this seems to be the best and complete thread for it).
I have seen the pictures posted above but the mark to set the timing to seems very poorly made.
My outboard is a tohatsu 9.9 d2 from 2004 and some previous...
