Re: Chrysler Sterndrive DANA 40
Hello!
Well let's talk about the end of my work!
After pulling the old tappets it was impossible to install the new one, diameter was really to tight... (8/100? mm m?tric).
I decide to hone the bore in order to enlarge it.
After this very long work, i had...
Re: Chrysler Sterndrive DANA 40
Hello!
So.... some pictures of my work, I hope that it would help someone in the world!
My special hand made tool for the nut
Everything ist out....
Here are the (tappets?) great moment!
I baught a special tool to take them away and it was really...
Re: Chrysler Sterndrive DANA 40
Well... I'm here again!
Pictures...
and then
The lower unit is yet totally dismantle
I Change the bearings
Till here, it was not to hard...
THE UPPER CASE... It's something'else (Eddie Cochran?)
Well, I asked you how to dismantle the upper part...
Re: Chrysler Sterndrive DANA 40
Hello everybody!
Thank you Bond-o for the adress i will ask them if they have something on my sterndrive. I wrote for 3 weeks to Chrysler's museum about my problem. I receive last week per post a kind answer of them, they were explaining that they have nothing...
Re: Chrysler Sterndrive DANA 40
Hello (Again) Everybody!
Thank you to proshadetree for his response. I try to insert pictures of my "wonderfull" sterndrive...
Mine....
and my boat....
I hope that is going to help you (or me in fact!)
Bye
Breakus
Hi Everybody!
I'm new on this forum, leaving in switzerland and just baught a Swiss boat equiped with Chrysler inboard 80HP (Simca) and sterndrive DANA 40. I already wrote something about it earlier in the morning but I can't find it anymore!
So I need your Help about sterndrive DANA 40! I...
