1990 Evinrude 150 VE150SLESB Jumping Spark
Motor is jumping spark on the bottom two cylinders where the clamps for the engine cowl are. There has been a hesitation mostly on warm restarts after fishing and sometimes the motor would surge before coming up on plane before straightening out and...
I am trying to find a part number for this switch on my motor as it has stopped working. I can?t find it in the drawings on Evinrude?s site. The switch ohm?s out open no matter the position of the lever and the gauge pegs out when I short the two wires from the switch that go to the gauge. Any...
After running to full operating temperature it drops #4 and #6. It will not run over 3500 rpms in gear like this (in the water). If I goose the throttle a few times it starts running right again. I have other posts about this but they are to long. I have put some bucks into this problem but I...
1990 Evinrude 150
Well, I pulled my fly wheel yesterday and figured out two things. It?s not near the trouble I thought it would be and there is some shigidy going on with my stator. There are two large coils on one side, and one large coil on the other side and then the other copper windings...
I have been having this trouble since I bought the boat 2 years ago but it has gotten worse. I just now realizing that it is dropping fire to a cylinder when this happens. I will list the history.
After running at low rpms the motor starts to sputter. It will not run over 3500 rpms in gear like...
I just replaced my spark plug wires and now I have no spark to my pugs! I made up my own wires with a kit reusing my old boots. I used new copper ignition wire. Is there a trick I need to know to make this work. I have never made plug wires up before but I am an electrician so I thought I should...
What is the purpose of the 6 check valves on the intake? (They don?t come with the carb kits do they?) I pulled my carburetors last night for rebuilding and I am considering replacing the check valves as well (or can I just remove and clean them?). She?s been very hesitant on start ups and...
I changed the oil in my lower unit today. I?ve used it for two seasons with out changing it (my first boat). I?ve never suspected a problem with it but believe in preventive maintenance. I noticed a very fine metallic powder on the top vent plug magnet. There were no slithers or flakes (I know...
I need to change the oil in my lower unit. I?ve had the thing for two years and I am playing catch up on maintenance now. It's my first boat but I am starting to catch on. What kind of oil do I put in it? Is there anything special I should know before doing this? Thanks
I am beginning process of changing out my VRO2 pump. I removed my remote outboard oil tank and emptied it. There is a small amount of debris in the bottom of the tank. I want to clear it and the oil line before running the motor with the new pump (as it?s a high dollar item). What do I use to...
Evinrude 150 VRO Alarming
I have a 1990 rude 150. It has the 3-wire vro2. I started getting an intermittent beep every 30 or 40 seconds while I had her out this morning. I put her on the trailer and took her to the house because I didn?t want to damage the motor. From what I have gathered this...
I have a 1990 Evinrude 175. I have had the same quirk with it for the two years that I have been running it but it is now getting worse. When the engine runs at idle for any length of time it gets a little rough. Then when I start out to run at faster speeds it just sputters. It will go back to...
