I have a 2005 Johnson 2 stroke engine. My diagnostic led display will sometimes cycle while running the boat. The led go through the cycle and I get a single beep which is same as when I first turn on the key. What is a good way to troubleshoot this problem. It is very intermittent.
I occasionally experience the main 20 amp fuse blow when I start the engine. This does not happen very often but when it occurs the engine has been run several hours with several restarts to move to other fishing areas. Does anyone have a schematic of this circuit? It looks like the starter...
I have a 2005 Johnson outboard with carbs. Engine runs great at higher rpms. I am have trouble running at trolling speeds after the engine warms up. What is a good troubleshooting procedure? Engine will stall at idle after warm up but still runs great at higher rpms.
After running the engine for a short period. I'll shut it down to fish and then restart it. It stalls out several times before I can get it to run without stalling. When running along at cruising speeds it runs perfect. What should I do to troubleshoot this problem? I plan to drain gas and put...
Where is the adjustment to lower the idle speed on a Johnson 2005 90 HP located? Do I adjust the throttle cable or is there a separate idle adjustment screw?
I've got a Johnson 2005 90HP. There are two cables entering the engine. It is difficult to see which cable is the shift cable. Is the top cable and trunnion for the shift?
I have the following
90 HP Johnson 2 stroke engine
17 1/2 foot center console (fiberglass)
Prop is 13.25 x 17 with 3 blades
Lowest trolling speed (at idle) is 4 mph
I would like to troll below 2 mph
What prop is recommended without causing damage to engine at higher RPMs?
We boat is on trailer with garden hose attached I can shift in and out of gear with no problem and cannot duplicate the problem. When boat is on the water and I shift out of gear I must go a little past the shift detent point to get it to come out of gear. I can't understand why it shifts...
I have a problem coming out of gear and going into neutral. The boat is a center console and when I shift into neutral there is not a positive out of gear detent or stop. Is this a simple adjustment? I brought it to a dealer and he sat on boat for two weeks before he adjusted cables. He said it...
Engine starts up fine. Runs perfect at top end. Sometimes it will stall out during idle speed. I can watch the tach go down and sometimes prevent stall by pushing the key in. What is a good troubleshooting approach to identify the problem?