bruceb58's latest activity

  • bruceb58
    bruceb58 replied to the thread Grease Seal to Spindle Fit.
    When the hub comes from the manufacturer, the hub is not full of grease. It takes many many pumps of grease to eventually see it come...
  • bruceb58
    bruceb58 replied to the thread Grease Seal to Spindle Fit.
    LOL...when I pull my bearings, I clean them...look for pitting and damage...repack them. I have seen the damage that using the LAZ-Lube...
    • 20180401_121459.jpg
  • bruceb58
    bruceb58 replied to the thread Grease Seal to Spindle Fit.
    well no...you don't. Even Dexter, in their manual, says to hand pack the bearings. If you hand packed the bearings initially and then...
  • bruceb58
    bruceb58 replied to the thread Maybe my turn for new boat time.
    I have two boats that get moored on lakes. Neither one needs to be painted.
  • bruceb58
    bruceb58 replied to the thread Maybe my turn for new boat time.
    I said I would never buy a boat with bottom paint...that is my choice since I don't need it! since I am either always in fresh water or...
  • bruceb58
    bruceb58 replied to the thread Maybe my turn for new boat time.
    I don't keep my boat moored in salt water. Bottom paint slows the boat down and looks horrible.
  • bruceb58
    bruceb58 replied to the thread Grease Seal to Spindle Fit.
    The whole purpose of a bearing buddy is to keep the hub slightly pressurized. You properly pack the bearings by hand to get the grease...
Show older items
Top