I have a 1996 Evinrude 150 V6 intruder. I purchased the motor used and was told by the previous owner that the motor wasn?t drawing 2-stroke from the reservoir and that I must pre-mix at 1:50 ratio (which I've been doing) and keep enough oil in the reservoir to prevent the reservoir low oil...
I have found a good deal on a new 2009 Honda 135HP 4-stroke (BF135 model). I currently have a 17' ranger bass boat with a 1996 Evinrude 150 V6 intruder, but the engine is starting to give me major hassles. I would like to replace it with something more reliable and the 4-stroke will save on gas...
How much play should there be in the control cable - if any, before it starts moving the shift lever linkage?
I have a 1996 Evinrude Intruder 150 V6 and am struggling with getting reverse. No amount of fiddling will get it right. I can manually get it by pulling the linkage up with my fingers...
I am having difficulty (after having rebuilt my powerhead) with getting both forward and reverse gear. No matter how much adjusting I do on the linkage adjustments its only one or the other. I know that an incorrect shift shaft height will have a bias towards one gear or the other.
Would anyone...
My 96 Evinrude 150 Intruder starts fine at cold start, idles and runs fine through all revs. The problem occurs when re-starting after having stopped for a while. The engine will start, but as soon as I put it into gear it splutters and dies. This occurs several times. Ultimately what I have...
Being a new outboard owner I have a few questions. I recently purchased a 1996 Evinrude Intruder 150 V6. It had a piston slap on the one cylinder so I had that cylinder re-bored, sleeved, and the relevant replacement parts installed.
On starting up, the engine idles and revs like a dream...
