Been trying to get this motor to keep running but with no luck.
Carbs were cleaned, motor has correct spark.
Fuel pump rebuilt, had ethanol debris in it.
Adjusted the idle circuit screws on the top two carbs with not much luck.
Holding the warm up throttle to 1500 rpm's and than adjusting the...
I don't have my manual for this motor yet.
But my seal has a small leak and supposibly can cause a lean issue I have been told. I would like to fix it before it gets worse.
Has any changed one of these?
Do I just remove the flywheel to gain access?
Can a seal puller be used to pull it out?
Thanks
I have contacted Seaswirl but with no luck on the subject,
So question is are there any schematics at all out there avialable for say a 1995 Seaswirl Bowrider?
