Bt Doctur's latest activity

if you have the HVS type dist(flat cap) ,there is a marked position

Usually the ecm controls the timing? all you do is install the rotor in its a marked position and the computer does the rest Need the...

your overthinking it if carb`d then sprat thru the carb till it stalls, TBI,EFI you use a remote tank with a winter mix to fog it

get the GM version , grind off the rivets, install the brackets on the new coil and bolt brackets in place. In time the rust will expand...

Or dance with the Devil

try looking where the block drain is , that where mercruiser put theirs, they T into the drain port

Well here`s one I could not figure out.Gm v6 mechanical pump Occasionally after about a 1 hour run I would be leaving black smoke and...

Sounds correct as long as the coil does require a ballast resistor. Some coils can run 12 volts to them like mercruiser coils and accell

looking to make contact with this member

remove the fuel lines at the sep, remove the tbi/rail connection, remove the water line hoses,remove the 2 nuts 26 and remove the CF...

everyone is pointing to the exaust when the ports in question are intake ports in the head. support the manifold and fill with water see...

you unhooked the block hoses but did you probe the brass quick connect in the block? Just seeing it dribble out instead of it pouring...

How did you drain the system ? IF a single point system my guess the engine block did not drain completely. You can verify by unhooking...

if the starter tries to turn the motor over but groans it indicates fluid in the cylinders. It it turns briskly then burns up you have a...

looks like it was the incorrect impeller to begin with