I have a omc side mount throttle that I took apart now I am having trouble putting back together . can someone send me a link to where a parts picture or site where i can look at the inside of this control box? Thanks in advance. here is a picture of it...
Hi,
Was wanting to know how I can check my switch to make sure it is the switch itself that caused my motor to trim itself up on its own and stayed there.
We took on some water a few days ago and my omc handle switch was broke anyway, so I took it out of the throttle handle. after we got back...
We just replaced the trim motor on my 84 Johnson 140 V4 about a month ago, I did or was having a problem with the switch at the handle on my osm throttle and when we out yesterday in the gulf we took on water from trying to free up our 3rd anchor.
We got back to shore the hull was full of...
We just put a new impeller in the water pump when we put another lower unit on my 140 v4 johnson I did notice with the hose on the ears when flushing it out that it dont pee as fast as it does in the lake or gulf is this ok or could something be clogged up somewhere from running it in the...
We just spent a lot of money on rebuilding the carburetors and rebuilding the fuel pump, new starter and another lower unit new impeller in water pump, and today a new ignition switch all because it was sucking air when we would throttle up to go it would act like it had water in the gas, but...
I just had the carbs rebuilt on my 1984 Johnson 140 V4 crossflo engine .
I go to throttle it up to get er going and it like vibrates and boggs down and wont go into any faster speed than 10 miles an hour , so then thinking we rebuild the fuel filter on it , cause I was at pelican marine...
I am having my seat /storage lids reupholstered and was looking where I could buy the fiberglass lid frame that the fabric is wraped around? Mine have old dried up rotten wood that was glued inside:( and I dont want to scrape it all out if I can buy new ones.. any help will be appreciated...
I just finished my 10 hour break in now I bought new champion plugs can someone tell me what the gap is on these plugs? I have a 1984 johnson 140 V4 crossflow that I just had the top half rebuilt, and also put in a used lower unit.
Another question is when this past weekend we were full...
I have a johnson 140 V$ lower unit making noises when I am running open . please advise on what to do. I just had the top rebuilt, and I have only 2 hours left on the break in time. is it more cost effective to just go get a lower unit from a boat yard most are going from $250-300. what do I...
Help is needed here bad, Just got back my Johnson 140 from a barter Job in Orlando and Put it in the lake this past weekend and had a hell of a time starting it once I did get it started I know it will smoke and sputter because of the higher oil 25-1 ratio I was told to use , I went to...
EDIT: Real sorry, gator.
Our rules do not allow soliciting, or the posting of personal data like phone numbers, Email addresses, etc.
You might try Craigslist.
I am going to have to rebuild my power head for my 84 Johnson 140 V4
But I was hoping to save money and maybe find someone that has a used motor that has a lower unit blown where I can use the power head, can anyone help or suggest what to do ?
A rebuilt is gonna cost around 2k not too...
Can anyone help me I am new on this forum so I hope I am in the right thread if not please guide me to the correct one :). I am looking for a used Throtle control box side mount for my bass boat. The Motor it belongs with is a OB 1990 Johnson 140 V4.
I have a sloppy warm up lever and the...
