Any chance you ever got this working? Can you give me the part number for the dash? I need to replace my dash as well and I can't find one for a 1996 anywhere. It's all busted up and just needs the dash.
I have a 1996 Crownline 225 CCR with a 454 Mag. To give a little on the history and clarify Ill make it brief. I bought the boat from a friend as i knew it but it had a bad valve guide i had to replace and had to put a new lower Bravo on the boat which came with the boat. Rebuilt the floor, new...
Im in the middle of finishing the build on my boat. It is a 1996 Crownline 225 CCR cuddy with the 454 mag. I have a bravo prop that need to be reconditioned but at the tune of $400 it will need to wait a week or two. I am looking to put the boat on the water to test out the engine and drive. Can...
I've pulled my plugs (autolite 25) and they are all black. Timing is @ 8 degrees, standing behind the boat smells like raw fuel, it uses a gallon of gas within 20 minutes or less just at idle. What can cause this. Fuel pressure is at like 30 psi and no fuel leaking anywhere.
I have a 1996 crownline 454 mag with Silent choice exhaust and I cant find a wiring diagram. When I hit the switch it lights up but the silent choice actuators do nothing. The exhaust stays close to thru hull. I can manually pull them open but i want the button to work. The guy I bought the boat...
1996 454 magnum mpi engine. I have water leaking from a exhaust valve into the cylinder and exhaust manifold. Looking under the valve cover I of course see mixed water and oil but no fresh water like what is leaking into the cylinder. How can fresh water get into the top of the exhaust valve but...
Ok so I bought a 1996 crownline with a 454 mag from a friend. I know the boat but I don't know what's wrong. First the boat was left open to the weather and the boat filled with rain water. It got in the fuel tank and after it was drain it was attempted to start. There was enough water in the...
So i bought a boat from a friend that has well had quite a few problems. He left the boat fill up with rain water and it got in the fuel system. I took the VST off and replaced the fuel pump, orings, and a fuse. Got it to finally prime and it started leaving
leaking fuel out the top of vst/fuel...
Ok a few of you know the situation with my 1996 crownline 225 ccr. I took it to the ramp finally and found a new issue. I found my leak into the bilge (intake pickup line at the water neck) but when i got the boat home i decided to take the outdrive off to do a reseal. When i looked at the...
I don't know much about the boat when I got the boat the lower was separate from the upper so I checked the seals on the top of the lower and put the lower unit back on the upper. I then did a pressure test and air leaks out somewhere as fast as it goes in. What is my next step to find the leak...
I just got through talking to the guy I got the boat from and he tells me that the boat had about half a gallon of water in the bilge after about a month of boating so Im panicking and wanting to check for where the water is coming from but the boat isn't ready for the water. I still need to put...
Now I have done this on Alpha's so many times I can do it in my sleep. However I believe the Bravo's are a different beast. I have looked everywhere for a shift cable replacement from a bravo but not a lot of luck. I believe it just needs a boot (because it leaks) but figure for the price of a...
Does anyone know how the fab a lower pickup only ear muff for a lower pickup only Bravo outdrive on the cheap or semi cheap? My boat doesn't have a flush kit and I don't want to have to look around for all the right size plumbing parts. Im hoping someone has the muffs or knows which parts to...
Looking at this connector I'm curious why there is a jumper built into the connector. I feel like its supposed to be there but I know base timing mode uses a jumper and my idle is about 1600 rpm. Cant find it in the manual unless your trying to put the engine in base timing mode.
I just bought a bravo one lower for my boat. When I took the outdrive out of the packaging these were loose I found the diagram and I know in which order they go in I think but I don't I know how it secures to the outdrive does it need to be pressed in? Everything seems to be there. But I can...
