Recent content by canary48

  1. C

    Mariner 60hp possible overheating

    Hi - apologies for length of post<br /><br />I have a 3 cylinder Mariner 60hp 1988.<br /><br />I disconnected my alarm wire as it was faulty and remained on at all times, the tell tale stream is strong and at WOT the tell tale becomes very hot but still not too hot to touch, it quickly cools...
  2. C

    Wire by Spark Plug/Water Jacket Gaskets

    Hi<br /><br />I have a Mariner 1988 3 cylinder 60HP oil injection engine.<br /><br />I have noticed by the top cylinder No1 there is a 4inch piece of wire which appears to go straight into the engine block approx 1/2 inch to the right of the spark plug, this wire is not on any of the other...
  3. C

    Power Tilt and Trim level top up

    Hi<br /><br />I am looking at topping up the oil level on my PT&T, I have a Mariner 60hp 3 cylinder 1988 2 stroke engine. I have raised the engine, unscrewed the large nut for the PT&T unit on the side of the motor (below the engine casing) and unable to see any oil level whatsoever. What level...
  4. C

    Manual and Filters - Mariner 60hp

    Hi<br /><br />I have a 2 stroke, 3 cylinder, oil injected, 60hp Mariner serial number 9537575, I premix rather than using oil injection.<br /><br />Being new to boating, I dont know a great deal about boat engines, I am wishing to learn therefore I am looking at attempting to service the engine...
  5. C

    Fuel/Oil mixture ratio

    I have just purchased a 2 stroke, 3 cylinder, 60hp Mariner serial number 9537575, it is approx 1989 and is oil injected. I will be premixing rather than using the oil injection as I dont wish to risk any problems with the oil possibly not being injected. The previous owner stated that the...
See more
Top