Recent content by cancan

  1. C

    SeaRay 1978 305 GM 188HP SMELL GAS IN EXHAUST

    1978 SeaRay 305 GM 188HP SMELL GAS IN EXHAUST.. Not sure if the float is off or if i have a bad cylinder... Any ideas or hints as to what to do/look for?? Thanks
  2. C

    Fuel problem

    Just pulled my lower end off a 1988 alpha one and changed out the sea pump.. Placed unit back on and started engine up to test pump to see if i did it right.. Checked forward and reverse then decided to let engine come up to temp and see if the thermostat was ok..After engine ( V6 ) ran for a...
  3. C

    Interior Care

    What would be best to use on the interior of my 1988 Searay 18ft run about... Original seats are perfect now, no rips or stains.... Would like to keep them that way is there anything i should be using....Thanks
  4. C

    What Will Work Best

    Good day...... I own a 1988 18ft Searay CB V6 4.3L... Has 21 pitch on it now which came original...Friend has a stainless four fin 14 pitch....The boat's RPM's runs about 5800 at full throttle now, not pulling anything... But the boat will be used to wake board and ski...Will this work on my...
  5. C

    1.2hp Gamefisher

    Not sure where to ask but as in the past with my 40 ski twin someone out there might be able to answer my question...I picked up a small motor over the weekend a 1.2hp gamefisher model #298-585120 (sears) wondering what the year is as well as gas/oil mixture. I'm guessing the gear oil would be a...
  6. C

    71 Twin Ski

    Just bought a 71 Ski Twin 40 hp...Model 40152B...Guy that sold it to me said it won't keep a charge on the battery...Where should I start...Thanks...
  7. C

    I,m outta here

    EDIT: No SPAM, please.
  8. C

    Steering Cable

    Well i finally got the 68 55 triumph running and went for a spin as my luck seems to go six miles up river my steering cable broke. Question can they be fixed or does it have to be replaced....
  9. C

    Prop Question

    I am about to put my prop back on my 68 55 triumph have tight shoud I go with the nut?
  10. C

    68 Evinrude shifter problems

    Okay so I dropped the lower end on my 1968 55hp Triumph to change water impeller and had to remove the solenoid housing and pull solenoid out to remove the gearcase fully. I changed the impeller and put everything back together and some how I've lost neutral and reverse. Gearcase was in neutral...
  11. C

    55 rude float setup for carbs

    Good Day.. Wondering if any one can tell me how to setup the floats in the carbs for my 68 evinrude 55hp triumph? Putting carb kits in and am not sure I understand the manual. Hoping someone can put it laymans terms. Thanks in advance for the help.
  12. C

    1968 55hp Evinrude 55873r

    My 55 triumph has the selectric push button shifter, is this considered an electric or hydro electric gearcase? Thanks in advance
  13. C

    68 evinrude lower end

    How much of a pain is it to drop the lower end and change the water impeller and if you have any hints please let me know? Thanks in advance for any info.
  14. C

    1968 55 evinrude bogging out

    Boat starts and idles well but when load is put on it it bogs out badly. The boat was sitting for several years. I put new fuel in with some carb cleaner in it. Just wondering if any one has any easy fixes or should i take it to a dealer?
  15. C

    1968 55 triumph

    How can you tell if the water pump and/or impeller is working on the 1968 55 triumph engine as there seems to be no telltale or **** hole?
See more
Top