Recent content by Can't Cast

  1. Can't Cast

    Need Pro Advice - Ignition Coil

    Hey all, I recently bought a 1978 Japanese Mariner model 15C (15 hp 2 cyl). I got it dirt cheap ($40). Previous owner said it ran several years ago, but won't start now. I cleaned the carb (properly), and checked fuel pump diaphragms (both OK), but she still won't crank up. Compression is 100...
  2. Can't Cast

    Test Post

    Can anyone tell me if this fish will make my boat run slower? It sure felt like it was going slower, I guess due to the extra weight.:redface:
  3. Can't Cast

    Can anyone ID this critter?

    Just purchased a used "japanese" Mariner (made by Yamaha). Need some professional help in identifying it, because I can't seem to find anything conclusive searching the internet. The motor reads 684C S 002009 on the ID plate. It's a short shaft, tiller operated, pull start motor. It has a 9.9 hp...
  4. Can't Cast

    Need Motor Identified...PLEASE!

    Just purchased a used Mariner (made by Yamaha). Need some professional help in identifying it, because I can't find anything conclusive searching the internet. The motor reads 684CS-002009 on the ID plate. It's a short shaft, tiller, pull start motor. It has a 9.9 hp cowling, and was sold to me...
  5. Can't Cast

    Yamaha/ Mariner tell tale problem?

    Greets everyone, I'm new here and could sure use some advice. I just acquired a used 1983 Mariner/ Yamaha model 5C (5 hp) outboard. I replaced the water pump assembly (complete) with all new parts. I then proceeded to crank her up in a trashcan full of water, and I noticed I was only getting a...
See more
Top