I just discovered that I have some Interlux VC bottomkote left over from earlier today. My question is: can I use it as long as it doesn't harden up? I've covered the remaining paint up, but won't be able to paint until tommorrow. Just wondering. Thanks.
I recently posted about a problem I had applying Gluvit, I put it on too thick. Well, I sanded the high spots and sags out with 40 grit, cleaned the hull and put another coat on. This time however, instead of brushing and tipping, I rolled it with a short nap foam roller and "tipped"...
I recently applied gluvit to my hull and had a problem controlling the thickness, what I'm left with is a very strong epoxy coating, but patches of really thick epoxy that need to be sanded. I tried sanding, but it gums up the sandpaper really fast. Is there an easier way? I did a search and...
I'm ready to install my new 16.5 gallon Tempo below deck gas tank and I have a question; will gasoline travel to the tank unimpeded if the fill hose makes a bend up and then down to the tank? This tank was the only stock tank that I could find that would fit.
I have used starboard before and it is very good stuff. My problem is I now have to replace my gas hatch 49" x 28" and a sheet of 48" x 54 " x 1/2" starboard is $150-$200! What is the difference between this stuff and polyethelene cutting boards? The only difference that I have found is that it...
I'm replacing my old 24 gallon,corroded metal tank with an 18 gallon polyethelene tank. I am going to use 4# foam to fill in the mid-deck. The original tank was completely foamed over. Should I foam over the plastic tank, or should I leave a void and possibly a water drain to the bilge? The boat...
I am almost finished prepping my 1972-17 Mako for painting and am wondering what the procedure is for applying new non-skid over original factory non-skid? Should I completely sand down the original finish, or just rough it? I will be using Interlux Brightside (with flattening agent, and...
