Recent content by capt. stabin

  1. C

    need bunker bracket for old trailer

    hey all of you bayliner guys I have a 89 bayliner trophy with the original trailer. I need to replace the bunker brackets but i want to get the same kind. does anyone know where i can find them. they are almost candy cane shaped.
  2. C

    need bunker bracket for old trailer

    I have a 89' bayliner trophy with the original trailer and i need new bunker brackets but i want to get the same kind. they are almost candy cane shaped does anyone know where i can find these?
  3. C

    force 125 bogging down

    I have a 89 force 125 and when i get up to wot after about 2min. it bogs way down. It doesn't shut off just bogs way down to ideal speed. I throttle down and then it goes again just not in wot. I can run all day at 1/2 to 3/4 just not wot. I have replaced the fuel pump with a new one all the...
  4. C

    looking for a trim and tilt

    Sorry, no solicitation on the forums.
  5. C

    does anyone know?

    does anyone know if a mercury prop #48-78118 17 will fit a 1987 force 125.
  6. C

    does anyone know?

    so i need a new trim and tilt for my force 125 1987 but i want a after market one. so if anyone knows a good place to look let me know. thanks for the help.
  7. C

    87 125 wont stay running at W.O.T

    I have a 125 that wont stay running at wot. i can run it all day at 3/4 but not all the way open. i got a NEW "not used" fuel pump but it did not fix the problem. anyone out there have any ideas?
  8. C

    need a prop

    anyone know what prop goes on a 1987 force 125 that is on a 1987 19' bayliner trophy? The motor came stock on the boat but when i got the boat it had no prop. also dose anyone know where i can get the prop, Or if anyone has one they want to sell me let me know.
  9. C

    fuel punp?

    does anyone know where i can get a new fuel pump for my 1987 125 force?
  10. C

    where is the idle screw

    i need to set the idle on my 125 force but i'm not sure where it is.
  11. C

    need help replacing kinpin

    i have a 1988 force 125 and i need to replace the kingpin. I took off the lower kingpin cap but i dont see how the kingpin and svivel bracket come off. can anyone help me?
  12. C

    I think i have a cloge

    i think i have a clog in my cooling system. water pump is good and pumps water at low speed but not at high speed. the t-stat is out of the motor so i know its not that. how can i flosh it out or get in ther to see if it is cloged up. when i took out the t-stas it was only the frame left i think...
  13. C

    force 125 way to hot!!

    I have a force 125 that runs way to hot. I replaced the impeller and the gaskets on the water pump. It has good water presure comeing out of the pee hole but the water is very hot with steam. the t-stat is not in the motor so i dont think that is the problem. the other thing is that the check...
See more
Top