Ok, I'm sure this has been discussed here before, but I can't seem to find what I'm looking for.
I currently have an 18HP 1966 Evinrude 2-stroke and want to get a more modern 9.9HP for the local under 10HP lake. What I am wondering is do I need to keep my current motor for when I want to go to...
Re: 1966 Evinrude 18 stuck in reverse.
Ok, so here's an update.
Got the impeller and grommet from O'Reilly Auto Parts this morning. New gasket for the side panel in the mail from iBoats(who knew first class mail was so fast). Did the install of the new parts, took me a few minutes to get...
What is the purpose of a tilt trailer for a boat? Recently purchased a 14' aluminum V-hull and have discovered the trailer is of the tilt variety. Thanks!
Re: 1966 Evinrude 18 stuck in reverse.
Well, desired today to go ahead and remove and replace the impeller. Here is what was found when openining it up.
What is with the frothy stuff inside? Is this normal? Also seeing as the impeller is curled over plan on replacing it. Found it...
Re: 1966 Evinrude 18 stuck in reverse.
Well, it ran like a scalded dog. GPSed about 21MPH. apparently something was off with the staring box as halfway back to the ramp it felt as if it was losing power. Got home and discovered the starting box top was ripped open and the cord was melted...
Re: 1966 Evinrude 18 stuck in reverse.
Found at least part of the issue.
Following Jasper's instructions found the lower rod isn't connected. Now, how to repair it. lol
Guessing I need to drain the oil and open up the lower portion?
New to this whole outboard thing. Just acquired the above mentioned motor that runs great, however it is stuck in reverse. Any suggestions on where to start in repairing it or what a repar might cost? Thanks!
