Recent content by ceasefire49Z

  1. C

    Grounding straps

    I am getting ready to put the outdrive back in but I have forgotten how the grounding straps go on. O know one each attaches to the end of the lift arms and I believe the clips fit on the feed tube . But I am stymied on where the bolt is to go a pic would be appreciated. The diagram someone...
  2. C

    Update

    Thought I would update on my ongoing project with the rinell 1988 192s. I purchased through a online charity auction for 400 bucks. I had to replace the transom,all flooring wood and redesigned the bulkhead stringer design from one provided to me by a member of the forum. I added an extra...
  3. C

    fuel filter part number

    Anybody know the correct part number for the sierra fuel filter water separator for a 1988 omc cobra sbc? I got one but its not close LOL
  4. C

    Bravo Transom Questions

    The correct depth in transom to reinstall transom plate I am drilling out the holes today for the 88 cobra transom plate. My question is I watched a few videos on drilling out the mickey mouse ears but all seem to be for a merc drive. So the holes are a little lower from the top and the cobra...
  5. C

    Gasket

    I have a 1988 rinell with a 5.7 cobra engine. I pulled the engine to replace transom and stringers. In the course of doing this I snapped off a few bolts on the transom plate that were stainless. It's at a machinists now having them removed. So I decided to replace the gaskets on the osco riser...
  6. C

    I noticed since I purchased

    the service manual on the advice of the world if boaters, That the adhesive used to embed certain gaskets in is omc since that is not available is the mercury stuff okay for bellows and exhaust y gasket or should I use a small amount of Red in the Exhaust y pipe groove. Also I noticed Frisco...
  7. C

    broken bolts

    trying to find the bolt size for the two bolts depicted here and shown as item 10. have searched all catalogs i could and to no avail. it appears to pass through and attaches to gimbal housing. i have the transom plate at machinisy ts to have them removed along with two star bolts on y pipe...
  8. C

    Install alignment tool

    I purchased an alignment tool and seal installer from heartland very heavy duty shaft. I purchased a gimbal bearing Install attachment that has a bolt running through the center that can be removed. If I take the bolt out the thing slides all the way down the shaft. There is no hole in shaft for...
  9. C

    Oil Pump

    I have an 88 Rienell 18.5 that I just put a new transom in along with stringers and deck. I am changing some items like fuel pump and thermostat ,impeller, Raw water pump etc since the engine is out and the boat sat for two years. I am looking for the oil pump replacement, is this a different...
  10. C

    Floating stringers?

    Did rienell put these in? 88 18.5 bowrider. When I took old stringers out that were rotted there were two 3/4 inch plywood pieces that ran the length of the boat from the walk through to the engine compartment stringers. The tank was in the middle and a piece of rotted ply on top of that then...
See more
Top