Recent content by Central Bears

  1. C

    2003 Mercury 90 hp 2-stroke oil resevoir?

    Someone told me I should disconnect the oil resevoir and run the oil in with the gas! They said there has been some issues with the oil resevoir's not working and burning the motors up.Motor has about 50 hrs. on it,and prevoius owner ran oil in gas with the resevoir also putting oil in fuel.When...
  2. C

    Converting a 25 in. shaft to a 20 in. shaft!

    Have come across a good deal on a 150 hp. Optimax yr. 2003,but would have to change the 25in. to a 20 in.How hard,and what details?Flex!
  3. C

    Scrathes on plexi-glass?

    How to remove fine scrathes on windshield,my hand had some resin on it and I touched windshield,tried to wipe off than used fine wet sand paper,it came off,but left some fine circler scrathes.What to use?
  4. C

    Boat painting!

    bought a nice proline flats boat at auction,drug repo,The marine patrol used it for alittle while and took the motor off and auction it off.Paint job is great,but it's that marine gray, want to paint white.Should I prime the gray than paint white?or should I sand the gray than paint white?just...
  5. C

    dt75 carb problem

    since i didn't get a reply the first time,i read jb"s how to ask a question.Looked thru forum's and found some of the same problem's with my motor.thank you,very helpful.mine is a 1996 dt75,started and ran good,stopped afew times and on last stop wouldn't start.pulled cowling and fuel shot out...
  6. C

    Suzuki DT 75!

    Finally after along baseball season,the old ball coach has time to take out the 17ft Mako he has been working on for ever.Me and my 10yr.old son go to the local dock to try her out.Trolling motor works fine,trim tabs and bait well.The motor a 1996 Suzuki DT75 with a new solis prop seems to be...
  7. C

    DT 75-Neutral Switch?

    I have a 1995 DT-75,I took apart the control box and installed the ignition and trim seperate on console.It would not turn over,so I removed the Neutral switch and it would turn over,but not start?Seems to me there could be a kill switch i'm missing in either the wiring harness or motor?Flex.
  8. C

    Installing Ignition switch!

    I posted in the Suzuki forum without response,Let me make this simple.Trying to install ignition,and trim switch to center console.They are coming off the suzuki throttle box that came with the motor.Any advice would ge great,Thanks Flex.:cool:
  9. C

    Suzuki Controls.

    I purchased a DT75 Suzuki from a friend of mine,low hrs.Put it on my 17ft.mako.I wanted to keep my Morse controls on boat,and not have to use the Suzuki side controls.I thought it would be easy to take the Suzuki controls apart and put the ignition switch and tilt and trim switch on the...
See more
Top