FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Second new fuel pump doesn't pump. It has three barbs , black one for gas 2 brass ones one big one small. Mounts on a fuel pump bracket which doesn't seem to have a vacuum port on it. I'm pretty sure Im hooking it up wrong but tried every configuration and ts not working! Driving me crazy...
sorry should have explained better. Going to replace it. I jumped it out and the motor fired right up had 12 volts on one side and zero on the other even when stroking the switch. Looked a tad confusing getting it off. Thanks!
I deep sixed my gas cap cause the chain broke. The marina said they are not sure what cap it is. Anybody have a place to buy one or what to measure so I get the correct one?
I pulled the flywheel off assuming it was like every other motor I worked on keyed. Much to my surprise is wasn't and I never marked it! I put number one cylinder at TDC. Then put the flywheel on with the pointer pointing at zero. With the 6 bolt holes if you use another one its way off. I...
I ordered the stator and rectifier. The thought I just had was I never marked the flywheel when I took it off. Anybody know how to line it up right? Last thing I want to do it mess up the timing. Never pulled a flywheel off without a keyway. The six bolt thing was different.
I pulled the stator after switching the red and blue wires with the red /white and blue /white.on the packs according to the site. The plugs went from firing 1,3 5 cylinders to 2,4, 6. From what I read this means the stator. I resistance checked the stator wires ( stator removed from engine )...
I am fixing this for a friend. The starter will barely turn the motor over. I removed all the plugs and it turns over easily spins fast. I have 90 PSI in al four cylinders all within a pound of each other. Marine battery is fully charged and load tested good. All connections are clean and...
Anybody know how to get the play out of the steering? The out drive bearing is ok been checked. Problem appears to be in the steering not the out drive. Anybody replaced the steering unit.
