Guys,
I'd like to replace my electric start cable. What have you guys used for cable? I can put on my own ends. Looked at McMaster for bulk cable by the foot and they probably have what I need if I know what to order. Mainly what I don't know is the wire gage. But if you know a specific...
Guys,
This new-to-me 1981 25hp Johnson does not have any mechanism to latch the motor in the raised position. All I see is the trim pin (was missing, made one this afternoon), the lock-unlock latch (which works fine), and what I have seen in parts explosion described as a shallow water lift or...
Guys,
My lower unit is pretty well pitted up. I want to prime and paint it but first I need to address the corrosion. I don't see any zincs. An on-line parts diagram shows the zinc kit at a mystery box, doesn't show where they actually go. Anyone know where they would be?
Thanks,
Byron
Guys,
Is that nasty hull cleaning solution safe for a lower unit that is missing most of the paint? This boat was kept on the water (fresh water) all summer most summers so the lower unit has a lot of corrosion. A lot of the paint is missing. I'd like to clean it up and repaint. Is hull...
Guys,
Prop nut does not align for the cotter pin when snug. It seems looser than I think a prop should be (I'm a novice with boat motors). Should I use a shim washer so the prop nut gets snug when the holes line up? How tight should the nut be? Right now it goes on finger tight then backs...
Guys,
I am considering the purchase of a 1986 Johnson 25hp, which I know nothing about. At idle I get exhaust and sputtering water from the two small holes just below the engine. When I wind it up I get gushing bubbles coming from somewhere down below the water in my rain barrel. Where is...
Guys,
I just registered here because I am considering the purchase of a 14' Sea Nymph with Johnson 25hp. Everytime I do a web search this forum comes up so it must be a good one.
Boat and motor are 1986, I think. Engine hadn't run much in past three years but with some fresh fuel it fired...