Recent content by chipman

  1. C

    fuel problem

    i was on the lake yesterday, i started up let it warm for a minute idled out of the no wake zone then got on plane, made it about 200 yards then motor sputtered and died. i cheacked everything over re primed and it ran for a couple min then died, motor runs fine if i pump primer bulb every 20-30...
  2. C

    gasket leaking

    hello everyone let me give you some background info first. i have a 1982 ranger bass boat with a evenrude 150 on it. last time i was on the water it ran good at low rpm's but on plane it would only run 5-10 minutes and act like i wasent getting enouph fuel, bogg down and sometimes die. i...
  3. C

    trolling motor, size question

    hello everyone I have a 1982 ranger bass boat "17 foot" i have an evenrude 150 on it, I plan to mount a bow mount trolling motor, my boat is set up for a 24 volt trolling motor, it has the 24v plug up front and the battery selector switch and power gauges, at the bow my question is how big of...
  4. C

    fuel guage

    hello everyone my fuel guage is not working, i have read all threads on this site and still cant figure this out, please help!!!! i have regrounded the sending unit on both fuel tanks, regrounded fuel guage, i am getting full power to pos connection on gauge "with key on", i am getting about...
  5. C

    quick fuel question please help

    question: when i run my motor on the water, i don't think i am getting enouph fuel. i am able to get on plain for a few minutes then motor boggs down then dies, i have to pump primer bulb and start senario over. I ran motor on the muffs yesterday and noticed the inline fuel filter next to...
  6. C

    oil alarm??? please help

    I am new to boating and new to this forum so any advice would be helpfull I bought a 1982 ranger bass boat with a blown motor, I recently installed a 1985 Evenrude 150, everytime i go to plain i get a low oil alarm, Beep beep beep every second or so until i shift into neutral then it stops...
See more
Top