Recent content by chomamma

  1. C

    High-Five Stainless Prop on a 3.0

    I have a chance to pick up a slightly used QuickSilver High-Five Stainless Steel Prop 13X19 pitch. I currently am running a 14.24X21 that is a dog out of the hole. Runs at 4900 and 38mph. Will this prop be too much? looking for skiing and tubing and knee boarding. Dont much care about top...
  2. C

    oil drain valve size 3.0l

    What is the thread size of the oil drain plug. 1/2 X 20? Thanks.
  3. C

    Why a water separator?

    Cars don't have them...... As long as you run enough gas often enough, why have them?
  4. C

    Over-Propped 3.0l Huh?

    Bayliner Capri 18 foot 3 inch with a 3.0l runing a 14 and 3/8" X 21 prop. Lightly loaded doggy hole shot running 5100rpms. Will check gps on speed this weekend. But if the tach is correct my rps are too high. Kinda of surprsing on a 3.0l engine. Wonder if my tach is off. I want better hole...
  5. C

    178 degrees seems hot?

    New to us, but only has 5 hours on engine. Replaced the impeller but still runs about 178 degrees after it warms up. Runs good and no bells. But everyone I see here says 160 is normal. I havent pulled Tstat but will. Also I'll check with infared gun this weekend. 2000 Bayliner with 3.0l
  6. C

    Carpet adhesive?

    I am currently restoring a 2000 Bayline 1850lx. I was wondering if I would be ok using just a indoor/outdoor carpet adhesive or should I try and find a specific marine application carpet adhesive? Any advice would be greatly appreciated. Thanks in Advance
See more
Top