Recent content by Chris H

  1. C

    9.8 water pump maybe?

    Hi, I have a 9.8 1972 merc which I use as a trolling motor, problems I'm having is from the pee out let I'm getting some water and a lot of smoke, after running for about 1/2 hr the engine just dies like as its over heated, I had replaced the impellar 3 months ago and it seamed to work OK but...
  2. C

    2 batteries, two motors, 1 isolator switch

    Hi Can Any one give me some help, I've a 200hp merc electric start,and and 9.8 merc electric start, duel batteries one isolator, am I ok to hook up both to the Isolator or do I need seperate swiches, will the charging of the batteries from the 9.8 merc have any problems on the 200 merc and vice...
  3. C

    Taco conection

    Hi and Happy Holidays, I have a merc 200 blackmax 1996 v6, runs great now, thanks to all for there past help, problem today is I'm try to connect a taco, RPM counter, ive got the extention lead that goes from the quick siver remote, this has four wires from it, the manuel does,t say which wire...
  4. C

    Merc 2000 left stitting for 18 months

    Hi All, Can any one give me some feed back as what to do, Ive just got me a used merc 2000 V6 1996 Oil injection, problem 1, its been sitting for some 18 months, should i Spray some oil into the cyindars before cranking the engine or should it be OK, also how do I test the stator to see if its...
  5. C

    Stator problems

    Hi, I have a V6 200hp merc, I put a new stator on and ran it for about an hour, it seamed ok, tried to restart it, no go, after running some tests I found one side of the stator not working(Open curcit) wouldn't spark one side of the V6, Replaced stator and same thing has happened, any help...
  6. C

    9.9 evinrude idle problem

    My little 9.9 engine starts OK but wont continue to run,runs when in gear and reves are up or if I pull choke in and out consantly it will keep running all be it not smoth when in gear it runs fine, I'm thinking its a carb problem, any pointers in the right direction I would by gratful, thanks...
  7. C

    9.9 bottom crankcase seals

    Can any one tell me which way up I should have the Bottom end crank case seals inserted, the manuel doesn't make it very clear, also If these seals have gone bad would i be getting an oil type resadue out of the out-let by the prop.
See more
Top