Recent content by ciliento

  1. C

    raw water hook up for shamrock

    does anyone know how the plumbing goes for a 1976 shamrock ford 302 I am having difficult locating a diagram, I have pictures of my set up that I can email if you care to see if you can figure it out
  2. C

    engine pictures needed

    I am looking for a diagram or picture of how a Ford 302 V8 is hooked up in a Shamrock boat 1978. I got the boat in pieces and rebuild an engine for it but I am having difficulty in hooking up the alternator and raw water cooling hoses, everything seems to be in each other way. I have the orginal...
  3. C

    check engine light and warning buzzer

    The check enigne light and warning buzzer activates on my 2002 225 honda comes on after you change modes of running, I can start the engine and run for anytime at an advanced rpm but when I reduce speed to a slow trolling speed the check engine light comes on and the buzzer sounds after sixty...
  4. C

    Know the RPM's ????

    I have a 2002 Honda four stoke 225 HP, 30 inch shaft on a bracket, on a 26 foot Goldline open fisherman, boat weighs 6000 lbs on a fishing trip more on the way in, all the time. At full throttle my four blade, stainless, 17 inch prop without trimming the engine up tachs at 5,000 rpms, trimmed...
  5. C

    need manual for ford 302 marine engine

    I am trying to put together a ford 302 to put back in a Shamrock boat and I am stuck cause I need a maunal or pictures to show where everthing goes and I can find what is missing, this is my first atempt at a rebuild and retrofit so any help is appreciated
  6. C

    What does it look like?????

    Anyone know where I can get a manual for a 302 ford marine engine, I am trying to put one in a Shamrock and since it didn't have all the parts when I got it, I am trying to locate some pictures or diagrams of the engine so I can put it back together, have it run and get it in the boat.
  7. C

    intake manifold plate

    I am looking for a tapered plate that goes under the carb for a 302 ford any suggestions on what it is called and were to find one? Also can you block off the vacum advance on the distubutor and still use it or do you have to get a marine distributor. I am the guy who is converting a 302 from...
  8. C

    marine carb vs auto carb

    I am converting a 1979 Ford 302 for marine use I have done the gaskets and the cam do I need to get a marine carberator or can I adapt the auto for marine use?
  9. C

    rear main seal

    Can anyone give me some advice on how to remove the rear main seal in a Ford 302 block, I have a 1979 block that has the split seal. The cap and the block.
  10. C

    cam change out

    I am marinizing a Ford 302 from a 1978 pickup truck and putting it into a Shamrock that had a 302 in it, do I have to change the cam out? Not sure if the cam in the Shamrockis the right one, the engine was missing too many parts to make it run, that is why we decided to swap out.
See more
Top