Recent content by citadel1995

  1. C

    1997 DT140 Power tilt/trim...

    I have 1997 Suzuki DT140 with Showa Power Tilt & Trim (I think Part #48503-94900-OED). The motor lifts & lowers fine and there are no leaks, When raised the motor stays up, (does not drift down). When in reverse the motor will raise, even at low throttle it will raise up, leaving me with no...
  2. C

    Swap 1979 351 with a 1987 350?????

    Once again, I need some help and guidance from all of you gurus. I have a 1979 OMC Ford 351 with 800 outdrive. The motor is toast. leaking water in oil, and oil spurting out of valve cover hole, water/oil mix coating the plugs, etc. etc. So I found a rebuilt 1987 350 fairly reasonable and...
  3. C

    No spark???

    1992 merc 25 hp was running great & just died. Motor turns got fuel but no spark. Fuse is ok! What can it be? Thanks
  4. C

    92 Mercury 25 hp rebuilt - Now no fuel pressure??

    I got this motor from a friend, & it was locked up. pulled it apart and rebuilt. I have 120psi in both cylinders. I rebuilt carb & fuel pump as well. It fires up great but as soon as it runs all fuel out of carb bowl its dies. the only way to keep her running is by pumping the bulb. I've changed...
  5. C

    Bennett trim tabs

    I bought an older set of Bennett trim tabs and was wondering if anybody knows what this gauge is exactly? Also just wondering if there is a limitation on the lengths for the hydraulic tubes from the pump to the actuators? Thanks!
  6. C

    Need Help Trouble Shooting 1996 Yamaha 150hp Lower Unit

    I have a 96 Yamaha Saltwater series 150hp. Was running great, shifting with no problems. Was going about 4500rpms when canopy railing flew up & snapped so I pulled throttle back fast, when everything was tied back down I gave it gas and the motor went into gear but when I hit throttle the motor...
  7. C

    nikki carb rebuil??

    rebuilding carbs on 1996 yamaha 150. there are no main air jets under the acces cover. manual indicates them there. shoulld there be jets there? it's the same on all three carbs.
  8. C

    Grumman Outlaw SW

    I've acquired a Grumman Outlaw SW jon boat that the previous owner took apart to recarpet and never completed the job. Does anyone know where I can get some information on how this thing goes back togther. I'm more concerned about whether or not I have all the parts or if I'm missing parts or...
  9. C

    1996 Yamaha Saltwater Series II 150

    Hello everyone, I'm new here but have been reviewing the threads for a little while now. I have my fathers 19-6 Aqua Sport and 1996 Yamaha Saltwater Series II 150hp V6. The motor has somewhere between 75-100hrs. I took it out last week and had hesitation issues and the RPM surges, I was reading...
See more
Top