Recent content by clj

  1. C

    Can you identify this prop?

    I have a set of 'mystery' props. I am trying to determine what they fit. Please see pics. I could not see any markings on the prop that I could google. The first pic is of the prop as viewed from the rear as it would be installed on the outboard. The second is of the side of the prop that...
  2. C

    Kill Switch recommendation?

    Hello, I seem to have gotten my grandson's 35 Evinrude working fine. It is electric start only (although I think you can take the cowling off, wrap a rope around the flywheel and yank). Whomever worked on the engine before hooked a bunch of things up backwards or not even close to correct. I...
  3. C

    198? Evinrude 35, starter keeps spinning

    A week or so ago, I posted about my grandson's outboard leaking fuel and catching on fire. That issue was fixed when I replaced the fuel pump with a brand new one. The old one leaked. After replacing the pump and checking for leaks, the engine fired up and settled down to a smooth idle. This...
  4. C

    198? Evinrude 35 fuel leak / fire

    Hello, My grandson has a 35 HP Evinrude, electric start, remote, 2 cylinder outboard. There is no tag on it, so, I do not know the specific model number or year, but I would guess early to mid 80s. The outboard was given to him and I was trying to start it for him yesterday. I hooked up the...
  5. C

    how do I remove compressor/supercharger clutch on Volvo Penta KAMD-44?

    Hello, I have done this once before but I cannot remember how. I am trying to remove the compressor/supercharger clutch and I cannot remember how to. I do not have a service manual and I have searched the www without relevant results. Thanks for any advice.
  6. C

    Volvo Penta KAMD 44 EDC not revving up in Forward, Help!!

    I have a single Volvo Penta KAMD 44 EDC. It is hooked via a jackshaft to a Volvo DP-E drive. It has dual stations. These engines are all fly by wire. The engine will start and if I press the N button and give it full throttle it will rev up to 2,000 RPM which seems normal. If I put it in...
  7. C

    Adding boost and EGT gauges for a Volvo-Penta KAMD44-EDC

    Hello, I just bought a new to me boat with a KAMD44-EDC engine, circa 2001. About 1,100 hours. The engine seems to run super, but, I wanted to add a boost gauge and a EGT gauge just so that I can spot potential issues before they become bigger issues. I was also thinking of adding a small led...
  8. C

    2004 V4 Johnson 115; dies and sputters at idle; runs fine over 1,500 RPM

    Hello, I have a 2004 Johnson 115, V4, 2 stroke, carb model. I do not use the boat all that often, but up until very recently, it has always run well. Now, the engine starts up fairly easily and idles OK right after it starts. Then, as it warms up, it starts to sneeze and then dies. Once it...
See more
Top