Recent content by clough

  1. C

    new sea nymphs

    Hey guys, I just got my new sea nymph - 1667T - VERY PLEASED!!! In my previous posts, you may remember that I had the tall transom that had to be cut down to a shorty - great move. This boat is exactly what I was looking for. The mechanic that cut down the transom said this was the most...
  2. C

    transom

    Hello, Has anyone cut down a 20" transom to a 15" transom on a 16' sea nymph (or any other) aluminum boat. I have a new Nissan motor (shorty) and the company sent a tall transom boat. Rather than go through the hassle of sending it back...waiting...I am considering cutting out a wedge of...
  3. C

    Princecraft deck boats?

    Hello all,<br /> Also struggling with decision between deck boats. Do any of you have a Princecraft deck and if so, how do you like the aluminum hull, ridability, etc... I boat on inland lakes, plan occasionally to on the great lakes... probably not in the ocean. Thanks, Rich
  4. C

    canvas replacement

    Hi, Does anyone know were I can get a canvas top (and other accessories) replaced for a 1972 crestliner trihull runabout - and two toned lounge seating (small type)? (75 HP, Stinger Johnson motor).
  5. C

    ignition switch bad?

    Hello again. Fuel pump problem was fixed (earlier posts) but now, my ignition does not disengage when I turn the key off (and even remove it). To stop the motor from spinning, I had to remove the battery ground cable. When I even touch it to the ground post on the motor, it sparks and the...
  6. C

    fuel flow

    Morning, I am still having a major problem with my 75 HP, 77Johnson Stinger. After a new fuel pump, new gas lines, cleaned carbs...I still get no fuel through the fuel pump (its not the tank or lines here either). It seems like there is no vacum (pulse?) from the engine to pull the fuel into...
  7. C

    Fuel delivery problem

    Hi guys, I have a 1977, 75HP Johnson Stinger on a 15' trihull that I'm trying to get up to snuff. It has run recently (3 wks ago) but it did had a some problems then (i.e., hard to start, once started, it idled great, but was completley sluggish out of the hole - felt like a cylinder was out...
  8. C

    starter spins won' engage

    Yikes, my starter now spins but does not pop up to engage the flywheel of my 1975 Stinger 75 horse Johnson (I'm a brand new member and more questions will likely be coming). Thanks.
See more
Top