Recent content by cobia17

  1. C

    1991 Force 120 idling rough, missing and 1 spark plug black

    The motor has new plugs, timing just done, fuel recirculation screens cleaned and good gas. Runs rough, especially in idle and sounds like it's missing. 1,3 and 4 cyl. Plugs are wet and no black residue. 2nd cyl. Has black soot residue. Can anyone tell me what this means?
  2. C

    1990 Force 120 no spark on 1st cyl, only spark on one of the two wires from cd pack

    Lost spark on 1st cylinder while trying to set timing. Switched the 2 wires that connect to the top 2 blue coils with a plastic pin connector. I then lost spark on #2 cylinder only, telling me that both coils are good. I just don't know how to troubleshoot the blue prestolite pack to eliminate...
  3. C

    1991 Force 120 thermostat location and temperature gauge connection sight?

    Hi, I would like to know the location of thermostat and the part number. Also, where on the engine would I connect a temp. Gauge. Thanks
  4. C

    1991 Force 120 impeller direction?

    I just removed impeller but did not pay attention to the direction it spun. Does anyone know if it's counter clockwise or clockwise? I have the water pump that has the metal tub that holds the impeller. Thanks for some help.
  5. C

    1991 Force 120 upper driveshaft washer/ retainer direction

    Hi, I just removed lower unit to replace impeller and a metal washer / retainer fell out of the mid section. I assume that the washer goes on the upper driveshaft below spline but I don't know which direction it goes. The washer is cupped like a bearing retainer. See pic. Also which direction...
  6. C

    Throttle not working on 1991 Force 120

    I just bought a 1990 cobia 1700 with a 1991 force 120 and I can't get the throttle to work. I replaced the cable but the throttle still wont work. It looks like three cam on the gear selector and cam from the throttle tower are meeting in same spot, not allowing throttle to move. I can't figure...
See more
Top