I have run into some false gauge readings. Im showing low voltage (battery charged, oil px is reading high, fuel gauge is stuck around 3/4. Its a gremlin because once in a while the gauges jump right back to normal. Could there be a common ground or wire all these gauges run off?relay?
98 4.3L...
I just pulled the motor on my 2003 4.3L GLO and I want to run it in the garage before I re-install it. Disconnected the Power steering pump and I have a connection line for the garden hose. It has a 10 pin wiring harness.
What would I need to do specifically wiring wise to run it. I will...
So I went the motor removal route. Made it as far as pulling the outdrive. Because of the salt water I cannot get the leg off. Tried using the trims to pop it off, block of wood, heat/pb blaster (two days) and nothing! One bolt(of the 6) on the left side seems welded. Probably time to start...
Had starter problems at the end of the year on the last trip. Went to replace the start and after a many hours trying to get the inside bolt buttoned up I finally realized the reason the bolt was missing. It didnt back out it busted off in the hole on the block.
almost impossible to get hands in...
Appreciate all the help! Turns out it didnt bust anything. The cable was out of adjustment. Got it to lock into gear and its solid onto the next compounding problem.
got my ski rope caught in the prop last year. Boat wont engage into gear soI suspect I sheared a drive pin or something. Where do I start??
98 Volvo penta SX
Hi all,
just pulled off my risers and it looks like the current gaskets are incorrect.
my 98 Penta 4.3l GL has a closed cooling system and my gasket has openings on all four corners. Should it not be a blocking plate with a closed cooling system?
assume the water just routes out the back of...
Hi all,
My Voltage gauge is reading 10-11v. Cannot run my accessories. Reads 10-11v with key on. I start the engine and it still reads 10-11v. All other gauges over-read slightly (fuel, oil px, temp). Ran it for a couple hours and on the lake and it seems to work ok.
Cleaned wire to the...