Some two-earred mooring bitts have holes (for ropes) in their center post. I want to install one near the bow of our little 1958 Feather Craft Rocket Runabout. The question is, should the rope-hole face toward the bow, toward the stern, or to the starboard side, or port side? Which would be the...
I have a late '80s Suzuki DT 65. The motor runs OK. This motor has oil injection. As we use the motor only in summer, (it's stored out of the water most of the year) I really don't trust the oil injection system, even though I keep it supplied with oil. (Oil does seems to flow; I just don't...
I have a 1988 Suzuki DT65.
How do I remove the choke and throttle linkage from the middle carbuetor?
It has some plastic clips attaching the linkage to the carb and I'm afraid of breaking them if I try to force them off.
Any help would be greatly appreciated.
I have a 1988 Suzuki DT65 that has not been run in about a year. It starts OK, idles OK, and runs OK at slow speeds. The problem is that as soon as I open the throttle, it bogs down and cuts out after about 2 seconds.
What can be the cause of this very irritating problem?
I have a model 4306C Evinrude 4HP (serial E0007176) built in 1973 that I'm tuning-up. What I would like to know is what is the gap setting on the <u>contact points</u>, and what is the gap for the <u>spark plugs</u>? (I'm using Champion J6C plugs) And is there a source for getting reprints of...
