Recent content by cpdad93

  1. C

    Stern drive ID

    Was making it too hard. Took off the 8 nuts, removed the rod, one tug and it came right out. Looked like it had new grease inside. Is that lower unit inspectable to see if anything is hinky inside? Thanks
  2. C

    Stern drive ID

    I am removing this stern drive so I can remove the 2.5. It’s in a 1987 and everything I look at says it should be a bravo one. Where it gets hinky is the speedo cable is not under the exhaust but mounted to the boat. Also the rod for the tilt does not have c-clips but nuts on both ends. The...
  3. C

    Mueller boat hill repIr

    Yes it seems to be two fairly thin layers of fiberglass, with a piece of foam sandwiched between them
  4. C

    Mueller boat hill repIr

    No idea, all I have is the tag on the back and what be a model number of 13199
  5. C

    Mueller boat hill repIr

    Anybody done one? Thanks
  6. C

    Mercruiser 120/140

    I have an 87 Larsen 120 mercruiser ( the wife’s fishing boat). The 120 is froze up. Is the 140 a direct swap as I did find one of those. A mechanic told me even other 2.5s may not be a direct swap as there are multiple bolt patterns on the 2.5. TIA, Don
  7. C

    1987 Larson 120 motor removal

    How heavy is that drive?
  8. C

    1987 Larson 120 motor removal

    Happy fourth to all. I have an old Larson with the 120hp in it. 2.5 GM I believe. Previous owner ran it out of oil so it is seized up. In wanting to pull the motor it says to remove the out drive. Can I not pull the motor out with the out drive left in? Thanks, Don
  9. C

    stackable boat storage

    I am not really cheaping out, just trying to avoid some big holes in my new 28x32 epoxy floor
  10. C

    stackable boat storage

    Has anyone made a homemade lift? I have a 1959 chris craft that I want to stack my raysoncraft on top of for the winter. I have had all kinds of crazy ideas starting with 4 posts.. One with electric winches and then a cross bar once its up, another with toothed track and four motors, and a...
  11. C

    1987 120 (2.5) bolt pattern

    I have an 87 larson runabout with a froze motor. Previous owner ran it out of oil. In looking for a replalcement block to rebuild, apparently gm has four patterns of these. Is there a list to figure out which one I have? I found a rebuilder out of an 88 s10 with a bad head, but it is 170...
  12. C

    Breaker bar rotating 2.5

    Is there a way to get a service manual that doesn’t cost a gold tooth?
  13. C

    Breaker bar rotating 2.5

    I bought an 87 Larson with a seized 2.5. I wanted to see if I could free it up prior to removing it. There doesn’t seem to be a good way to get a wrench on it. Any help would be appreciated. Thanks, Don
  14. C

    OMC tilt

    I am sure this has been addressed but I can't find it...Like many OMCs my tilt clutch assembly was full of water..motor works fine, the clutch pack is out but since I was in there I wanted to replace the seals on the outdrive side and add a drain plug. I removed the snap ring but can seem to...
See more
Top