Recent content by Cplsteve

  1. C

    Boat construction question for tank removal

    All the wiring is what goes up to the console for the nav lights, pumps, chargers, and the steering hoses as well as motor harness. So the part I’m really confused about is how do I support the hatch so it can be secured to the deck?
  2. C

    Boat construction question for tank removal

    No I don’t have the flange piece. I tried to tilt it out also, but with the way the tank and boat are it wouldn’t fit. Trust me my last option was to have to do any cutting.
  3. C

    Boat construction question for tank removal

    In the first picture is the gap of extra deaf that was removed. The red outline is where the console sits. The second picture shows in red where the lip use to be for the panel to sit down on the deck and be screwed down. The blue outline shows the lip that’s left on the front and rear. Do I...
  4. C

    Boat construction question for tank removal

    I have a 2001 Flats and Bay 18x8. I had to replace the fuel tank due to age and leaks. The boat had a removable panel to get to the tank but it was not wide enough to remove the old tank and I had to do a little extra cutting. My question is what is the best way to replace or fix the area where...
  5. C

    2001 F115 ISC idle speed control valve stickig

    Yes the rail pressure is dropping down to 10 psi when running. I’m guessing the pump from Amazon probably isn’t working. Is it worth getting the OEM pump for this motor?
  6. C

    2001 F115 ISC idle speed control valve stickig

    Yes when I shut the motor off it rattles. When I turn the key on I can hear the high pressure pump kick on for a little like to prime. So what would explain the fuel pressure dropping down to the point it stalls out. When running the boat on the water or the motor in a test tank, I can put it...
  7. C

    2001 F115 ISC idle speed control valve stickig

    So I think my isc valve is bad but wanted a second opinion. Boat starts up and idles fine for about 7-8 minutes then a starts to stumble for a few seconds and dies. Starts right back up. Once running I go to give it throttle abs it just stumbles and dies out. I ran the yds on it tonight and...
  8. C

    Fuel pressure

    With the engine off key on the pressure drops. When u first turn the key on the pressure jumps to 40psi as you hear the hp pump activating and then it starts to drop off with psi. After water testing with the fuel pressure gauge it runs at 36 psi and when you go to full throttle it drops to 20psi.
  9. C

    Fuel pressure

    Yes but also when the motor is running the mechanical fuel pump is pumping unlike when the motor is off
  10. C

    Fuel pressure

    I have a 2001 Yamaha f115TLRY at idle I’m getting about 31 psi. When I turn the key on the fuel pressure starts dropping. I have been barreling this issue for a while and have checked everything I know. Had injectors cleaned and checked, replaced low pressure pump, replaced high pressure pump...
  11. C

    2000 Yamaha 115 4 stroke won’t go to full throttle

    So I checked the timing with the timing light. It is showing 1 notch to the right of TDC mark.
  12. C

    2000 Yamaha 115 4 stroke won’t go to full throttle

    I have to get a fuel pressure gauge to check the rail pressure. I have not tried a timing light did not know it was needed on fuel injected motors, but I can definitely try it out. A smoke test is a machine that puts an inert smoke/fog into the system to look for leaks. Mainly used in...
  13. C

    2000 Yamaha 115 4 stroke won’t go to full throttle

    Hello I don’t know if this has been addressed yet. I have a 2000 Yamaha f115TLRY starts up idles good and runs perfect at low speeds. When I give it full throttle it falls on its face. If I pull the throttle back slightly it will run at about 3800 rpm. I have replaced the following all filters...
See more
Top