I am testing the output of my power pack (15 hp. 4stroke) I dont have the Stevens PL-88 adapter. I picked up a peak reading meter from work and a 10 ohm resistor, and I asked the technician if this was a DVA meter. He said he didnt know what that was. No one in the lab knew what DVA stands for...
I'm still experiencing some intermittent spark conitions on this motor. If I can get my motor to start, it will run fine. However if it doesnt start, I hook up my spark tester and see that I have no spark. I jiggle cables, use hair dryer to heat stator, or powerpack and usually I can get it to...
I'm testing the charge coil under the flywheel on my 1995 15 hp 4 stroke manual start Evinrude. The motor has an intermittent spark problem hot days it generally shows no spark (using spark tester) cool evinings it shows spark. I have been suspecting the power pack. Today however, I thought I...
I'm looking for this power pack for my motor 95' 15 hp 4 stroke pack number OMC0586650. Very few places even have it and when they do, they cost $259- $ 379.does anyone know of a place to buy this part for less???
Ive got this 95 evinrude 15 hp 4 stroke. This has the power pack with the sensor built in and mounts below the flywheel
It has developed a problem of not getting spark all the time. Ive been running tests on the various components to try and isolate the cause for the past week. I seem to be...
This motor has become my passion. I am still trying to isolate whats causing my motor to lose spark and then suddenly (early evening) start working again. (done this 3 different days) This beats me! I chilled the ignition coil (has a crack) and made no differnce in regaining spark. Power pack...
My motor is driving me nuts! This motor has run great this summer then the other day it wouldnt start.
I have spent hours trying to figure out why sometimes I have spark and sometimes I dont. I have gone by the manual testing the various componets in my ignition system. Just when it appears...
Ok, I'm trying to determine whether the flywheel key in my motor 95 model 15hp 4 stroke evinrude is OEM factory or hardware type. key is OMC 0307480 I bought this motor used and I want everything to be "right" on it. I dont want the key to shear when I need this back up motor in an emergency and...
I'm working on my 1995 Evinrude 15hp 4 stroke. I want to get this motor to start on the 1st or 2nd pull. Sometimes it yanks my arm back like its out of time.
I find that my flywheel key has 2 tiny small cuts in one side They are rectangles about .010" x.020". They are about .010 deep. Each of...
This motor has always required several pulls on the rope to start it. Recently it just wouldnt start. I took the cover off and pulled the plugs. tested the ignition with my spark tester and found no spark. I peck on the power pack with a wrench and pull the rope some more. Now I have spark. I...
I purchased the Sierra water pump kit. 18-3402 for my 69' model Evinrude 9.5 HP. modle 9922S.
It came with 2 seals. one gold and one green. The gold one fits the bottom housing plate (with sleeve bearing). I have pressed it into place. The Gold one has a slightly larger OD 1.005" and a .503"...
I am considering buying an Evinrude outboard that I'm told is a 15 hp but it has 9.9 decals on the cover. (used on small lake with 10hp max restriction.)
With the cover off, how can I tell if this thing really is a 15 hp?
thanks, Cropduster21
I would like to know the hole diameter of the main jet on the 9.5 hp motor.
I am going to try and clean my main jet without removing it from the motor. I dont want to disturb the gasket and seal I have on the bottom of the carb. I have the carb bowl soaking with an ounce of carb cleaner (top...
I just bought this little motor yesterday. Estate sale. The man selling said it was his fathers and it would probably need to have the carb cleaned and a new impeller. I'm pretty handy with motors so I bought it. I need an aux motor for my center console boat.
I'm working on it today. The...
I'm new to the forum. My motor is 27 years old and has never had the impeller changed. I am going to be using this motor as a kicker on my larger boat and thought I had better change this part now and not run the risk of having it quit and ruin the motor. I have it out. Its 8 blades.
part...
