Current visitors

Home
Members

Crosbyman's latest activity

C

Crosbyman replied to the thread 1997 70hp won't idle properly.

post mdl# !

Apr 8, 2025
C
Crosbyman replied to the thread e-tec 40hp oil use.

ETEC oil consumption is fairly low specially if you run on XD-100 setting if your engine heats up due to low oiling it will tell you...
Apr 7, 2025
C

Crosbyman replied to the thread 2001 Evinrude 150hp FICHT reverse isdue.

the oil unless corrupted and creamy isn't the problem. the oil may simply carry metal chips.... confirming gear damage if any...

Apr 7, 2025
C
Crosbyman replied to the thread Johnny Rude Starter Housing - E or JE?.

page 294 Johnson service manual (BIBLE)
Apr 6, 2025
C
Crosbyman replied to the thread 2001 Evinrude 150hp FICHT reverse isdue.

the shift rod is adjusted to specs by rotating the shaft to shorten it or lengthen it . IF you did not touch the shift rod recently it...
Apr 6, 2025
C

Crosbyman replied to the thread Golden Jubilee Evi Sportwin 10 - Should I convert?.

nice job! you can reorient the fuel pump cover 90 degrees down to shorted the hose and free up some space up to you

Apr 5, 2025
C

Crosbyman replied to the thread Johnny Rude Starter Housing - E or JE?.

see bulletin 10hp rope # 203821 72.25 inch of 7/32 size pull cord .

Apr 5, 2025
C

Crosbyman replied to the thread 1959 Evinrude 5.5hp 5518 prop install.

? is it the prop that came with the engine or a replacement ? was it on the prop shaft when you acquired the engine ?

Apr 3, 2025
C

Crosbyman replied to the thread OMC p/n 0335626 (nipple, fuel & oil) purpose?.

you could probably take 2 short pieces of clear rigid plastic of tubing and mushroom the ends a bit to fit the hose section...

Mar 31, 2025
C

Crosbyman replied to the thread 1969 85hp Starflite, ignition system change???.

I am no mechanic just done lots of trouble shooting in data transmission eqpt used by Telcos and fixing up oldies (50s to mid 70s) ...

Mar 28, 2025
C

Crosbyman replied to the thread Golden Jubilee Evi Sportwin 10 - Should I convert?.

where would you put nylon inserts ??? just mount the plate over the bypass cover using tad longer bolts as you see fit. the pump is...

Mar 28, 2025
C

Crosbyman replied to the thread 1969 85hp Starflite, ignition system change???.

OK I guess the main thing now is to restore sparks from the coil. the CDI may have blown due to the high voltage spikes going...

Mar 28, 2025
C

Crosbyman replied to the thread 97 90Hp Johnson trim tilt.

no expert on T&T sticky valves but if you can drain the thing...... me...only me... I would load it up with WD40 and try to cycle...

Mar 28, 2025
C

Crosbyman replied to the thread 1969 85hp Starflite, ignition system change???.

sorry to ask... how this all this come about or is this simply a new to you engine ? ... IF " NOT NEW TO YOU" when did the problem...

Mar 28, 2025
C

Crosbyman replied to the thread 1969 85hp Starflite, ignition system change???.

if you carefully keep any single test wire from the engine frame there would be no " leakage" to ground through open air space. The...

Mar 28, 2025

Show older items

Home
Members

Top