Ive read a lot of posts on here about bogging when going to full throttle. I had the same problem on a Johnson 87 60 hp outboard. My problem was the jets were all clean and fuel lines and pump all clear. Everything seemed to be working ok but still had that fuel delivery problem from idle to...
I have a built in gas tank on my boat and it doesnt have an anti siphon valve on the tank The line at the gas tank,you cut the connection off and run the straight hose to the fuel pickup tube which all it is is a tube that runs the height if the gas tank and the other end has a connection for...
87 Johnson 60 hp. Problem i got is when i tilt the motor all the way up(it will go all the way up),the motor will go up but if you leave your finger on the switch even a split second after it goes all the way up it will blow the main fuse. Its a 20 amp fuse. Checked all wires looking for a loose...
Doubling oiling is reccommended when you have an engine rebuilt on most motors. Whats the harm to double oil all the time?? I know it would foul the plugs out quicker but any other problems?? Why i ask this is because when i run 50-1 in a 60 hp johnson it doesnt seem like it smokes at all at...
Doubling oiling is reccommended when you have an engine rebuilt on most motors. Whats the harm to double oil all the time?? I know it would foul the plugs out quicker but any other problems?? Why i ask this is because when i run 50-1 in a 60 hp johnson it doesnt seem like it smokes at all at...
1988 60 hp johnson motor. I am rebuilding the carbs and i see theres a round rubber-like gasket that goes over the brass tubing inside the carb. Is this an important gasket or can i do without it? Thanks
Had my 88 60 hp motor rebuilt. It seems like it starving for a little fuel when you throttle up occassionally. Carbs have been rebuilt and jets are clear.All 3 cylinders were bored out with the number 1 being bored out .040. You think i need to have bigger idle jets??
Took boat out yesterday. Its a 1988 60 hp Johnson. Ran great,but after running WOT for about 6 minutes the motor died like it was out of gas . It restarted fine but wouldnt go faster than idle speed afterwards. Sitting in neutral it would rev up fine.Came home and took carbs off,they all...
I have a 1988 johnson 60 hp motor. It runs fine but occassionally when you give it WOT it sputters but if you push in the key for the choke it takes off. You may go all day and it wont do it at all and the next day everytime you give it WOT it sputters but hit the choke key it takes off and...
I have a humminbird wide 100 depth finder that i just use for checking the depth of water im in,ive got another 1 i use for finding fish. Question would it be better to mount the transducer in the boat or on the transom?Its on the transon now and it works great til you hit about 20 mphand it...
First of all great message board... I have a 1988 johnson 60 hp 3 cyl. motor. It runs just fine but the tach reading is reading at 1400 rpm's at idle and WOT it reads at almost 7000 rpm's. Question...is it worth adjusting this tach or better off buying a new one.. Thanks<br />P.S. the prop on...
